Description
Hazard Light Switch For PEUGEOT 3008 And 5008 First Generation
This replacement hazard light switch is designed for first generation Peugeot 3008 and 5008 models and is identified by part code 96652440ZD. Ideal for professional workshops and DIY enthusiasts, this durable switch restores reliable emergency light operation and dashboard feedback. The unit matches original fitment, allows straightforward installation into the center dash control area and is a common direct-swap spare when the original push-button becomes intermittent or inoperative.
Technical Information
- Manufacturer: Stellantis / PEUGEOT
- Model: PEUGEOT 3008 I; PEUGEOT 5008 I
- Product Codes: 96652440ZD
- Additional Numbers: Not Available
Function
The hazard light switch activates all turn signal lamps simultaneously to warn other road users in emergency situations. It provides a mechanical/electrical interface between the driver and the vehicle’s exterior indicators and typically includes an illuminated symbol to indicate the hazard circuit status on the dash.
Replacement Procedure
- Safety First: Disconnect the vehicle battery before starting work to avoid short circuits and prevent accidental airbag deployment.
- Remove Trim: Carefully pry and remove the surrounding trim panels of the center console using plastic trim tools to avoid damage.
- Access Switch: Unscrew or unclip the switch module from its bracket in the dash. Keep fasteners for reassembly.
- Unplug Connector: Release the wiring connector latch and disconnect the harness from the back of the switch.
- Install New Switch: Connect the harness to the replacement unit, secure the switch in its bracket and reassemble trim panels.
- Test: Reconnect the battery and verify hazard lights operate correctly on both sides and that the dash indicator illuminates.
Installation Recommendation
Work should be performed by a qualified technician or an experienced DIYer familiar with dashboard trim removal. Use plastic trim tools to prevent scratching, and inspect the wiring connector and contacts for corrosion or damage before fitting the new switch. After installation, check turn signals and hazard activation on both sides and confirm the dashboard indicator works. If connectors show corrosion, clean contacts or replace the connector to ensure reliable operation.
Why The Part Fails Most Often
Common causes of failure include mechanical wear from frequent use, internal contact oxidation or corrosion, melted or cracked plastic from heat exposure, and occasional solder-joint failures on the switch PCB. Moisture ingress from spilled liquids or roof/leak paths can accelerate electrical faults. Symptoms typically include intermittent operation, no illumination on the dash, or a stuck button.
Notes For Mechanics And DIYers
Keep the original part code (96652440ZD) when searching for replacements to ensure correct fitment. This switch is a commonly replaced item in first-generation 3008/5008 dashboards and is a cost-effective repair to restore full hazard light function and vehicle safety.
