Description
Throttle body for 1.0 1KR engines of Citroën C1 and Peugeot 107. Throttle body housing. Hoses are not included.
Premium replacement throttle body designed for the 1.0 1KR petrol engines fitted to Citroën C1 and Peugeot 107. This unit restores correct air intake control, improves throttle response and idle stability, and is often sought by mechanics and DIY enthusiasts under the part numbers 0280750192, 22030-0Q010, 163617 and 163645. The housing is supplied; intake hoses are not included. Ideal for routine repair or when symptoms such as unstable idle, loss of power or throttle hesitation appear.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën C1, Peugeot 107 (1.0 1KR)
- Product Codes: 0280750192, 22030-0Q010
- Other Numbers: 163617, 163645
Function
The throttle body regulates the volume of air entering the engine according to input from the accelerator and engine management system. Modern units incorporate an electronic actuator and a throttle position sensor so the engine control unit can precisely manage idle, acceleration and emissions.
How To Replace
- Disconnect the battery before starting the repair.
- Remove the air intake hose and airbox to access the throttle body.
- Unplug the electrical connector and any vacuum lines attached to the unit.
- Unscrew the mounting bolts and carefully remove the throttle body from the intake manifold.
- Clean the mating surface on the intake manifold and fit a new gasket where required.
- Install the replacement unit, tighten bolts to the manufacturer’s torque specification, reconnect electrical and vacuum lines, and refit the air intake system.
- Start the engine and allow it to reach operating temperature. Perform throttle adaptation/idle relearn if required by the engine management system and clear any stored fault codes.
Installation Recommendations
- Always follow manufacturer procedures and torque settings.
- Replace the intake hose clamps and gasket if damaged to prevent vacuum leaks.
- Check electrical connectors for corrosion and ensure secure connections.
- Use a proper throttle adaptation procedure or diagnostic tool after replacement to ensure correct idle and throttle response.
Most Common Failure Reasons
- Carbon build-up on the throttle plate causing sticking or erratic idle.
- Faulty throttle position sensor or electronic actuator failures.
- Electrical problems such as damaged wiring or corroded connectors.
- Vacuum leaks or deteriorated intake hoses affecting air metering.
- General wear after high mileage or exposure to contaminated intake air.
Typical symptoms of a failing throttle body include unstable idle, stalling, poor acceleration, reduced fuel efficiency and an illuminated check engine light. There is no fixed replacement interval; issues commonly appear after high mileage or as a result of contaminated intake air. Use the listed product codes when searching to quickly find the correct unit for your vehicle.
Part numbers: 0280750192 / 22030-0Q010 • Additional references: 163617, 163645
