Description
Passenger Airbag Switch for Citroën C1, C2, C3 including C3 Pluriel and Peugeot 607
Product Overview
This genuine replacement passenger airbag switch restores the manual ON/OFF control of the front passenger airbag for selected Citroën and Peugeot models. Designed to match original equipment fit and function, the switch is commonly sought under part numbers and references shown below. Ideal for professional workshops and DIY mechanics who need a reliable, plug-in replacement for a faulty or non-functioning airbag disable switch.
Function and Application
The passenger airbag switch allows the driver or service technician to deactivate the front passenger airbag when a rear-facing child seat is installed or when required by vehicle configuration. When the switch is set to OFF, the airbag control logic prevents deployment of the passenger airbag in the event of a collision. When set to ON, normal airbag operation is restored. Proper operation of this switch is critical for safety and correct restraint system behaviour.
Compatibility
Fits the following models (verify year and trim where applicable): Citroën C1, Citroën C2, Citroën C3, Citroën C3 Pluriel and Peugeot 607. The part is commonly searched by its product references listed below.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën C1, C2, C3, C3 Pluriel; Peugeot 607
- Product Codes: 96373215XT, 95835T02, 8216E6
- Other Numbers: None Listed
Replacement Procedure (General Guidance)
Basic replacement steps for experienced mechanics or competent DIYers:
- Always disconnect the negative battery terminal and wait a few minutes to disable the airbags system before starting work.
- Remove the trim panel or dashboard bezel surrounding the switch—this usually requires gentle prying with trim tools to avoid damage.
- Unplug the electrical connector from the old switch and release any retaining clips.
- Fit the new switch into the mounting, secure clips, and reconnect the connector ensuring a firm contact.
- Refit the trim, reconnect the battery, and cycle the ignition to verify indicator behaviour. Confirm the switch clicks distinctly between ON and OFF and that the passenger airbag status indicator (on dash or console) reflects the switch position.
Installation Recommendation
To avoid damage to the SRS (Supplemental Restraint System) circuits and connectors, follow manufacturer procedures: disconnect the battery before removal, use non-marring trim tools, and avoid shorting connector pins. If the vehicle displays SRS fault codes after replacement, diagnosis with a compatible diagnostic tool is recommended to clear codes and confirm system integrity. If you are not experienced with airbag systems, have the replacement performed by a qualified technician.
Why This Part Most Often Fails
- Mechanical Wear: Frequent switching over many years can wear internal contacts or mechanical detents, causing intermittent or failed operation.
- Contamination And Corrosion: Moisture or dirt ingress behind the dashboard can corrode contacts or connectors, leading to poor electrical continuity.
- Impact Damage: Front-end collisions or hard impacts can deform the switch housing or wiring, rendering the switch inoperative.
- Electrical Faults: Connector damage, broken wires, or poor grounding can mimic switch failure even if the switch mechanism itself is intact.
Why Choose This Replacement
Replacing a worn or faulty passenger airbag switch restores correct control over the passenger airbag function and ensures the vehicle’s safety systems operate as intended. Using the correct reference numbers when searching increases the chance of fast, accurate sourcing. Suitable for workshops and competent DIYers who require a direct-fit replacement matching original specifications.
Keywords
Passenger Airbag Switch, Citroën Airbag Switch, Peugeot Airbag Switch, Citroën C1 C2 C3 C3 Pluriel Airbag Switch, Peugeot 607 Airbag Switch, Part Number 96373215XT, 95835T02, 8216E6
