Description
Window and mirror switch for Citroën C8 and Peugeot 807. Controls front and rear windows and exterior mirrors. The part shows signs of use, it is fully functional.
Product Overview
Replacement window and mirror control switch suitable for Citroën C8 and Peugeot 807. This unit operates both front and rear electric windows as well as the exterior mirror adjustment, providing centralised control from the driver’s door. Supplied used but fully functional — ideal for mechanics and DIY enthusiasts searching by part number.
Why Buy This Part
- Direct-fit control module for Citroën C8 / Peugeot 807 — often searched by OE numbers 14996390XT and 6554RY.
- Saves time on repairs: replaces faulty door switch assemblies that cause window or mirror malfunctions.
- Practical choice for workshops and home mechanics looking for a cost-effective replacement component.
Installation Recommendations
Remove the door trim panel to access the switch module. Typical steps: disconnect the vehicle battery, carefully pry off trim panels using plastic trim tools to avoid damage, unplug the electrical connector, release any retaining clips or screws, and withdraw the old switch. Fit the replacement by reversing the procedure and verify window and mirror functions before reassembling the door. Use care with connector pins and plastic clips — damaged clips are a common cause of fitment issues.
Most Common Failure Reasons
Control switches fail most often due to worn internal contacts from frequent use, ingress of moisture or dirt, or broken plastic actuators and mounting tabs. Intermittent operation, stuck buttons or non-responsive mirror adjustment are typical symptoms. Failure frequency depends on use intensity and exposure to moisture or contaminants.
Technical Information
- Manufacturer: Citroën / Peugeot (Stellantis)
- Model: Citroën C8, Peugeot 807
- Product Codes: 14996390XT, 6554RY
- Additional Numbers: –
Fitment Note
Compatible with driver-side door assemblies on Citroën C8 and Peugeot 807 vehicles that use the listed part numbers. This switch is commonly sought under the referenced codes; confirm visual match with the existing unit before installation.
Practical Tips For Mechanics
- Keep a set of plastic trim tools and a small selection of Torx and Phillips drivers on hand for fast removal.
- Inspect wiring harness and window regulator when diagnosing window issues — a faulty switch may mask wiring or motor problems.
- After installation, cycle each window and mirror to ensure proper operation and to seat electrical contacts.
