Description
Window And Mirror Switch For Citroën C3 II 2009–2016 With One-Touch Operation And Electrically Adjustable And Folding Mirrors
This replacement power window and mirror control switch is designed for Citroën C3 II models produced between 2009 and 2016. It integrates driver-side window controls with mirror adjustment and electric mirror folding functions, including one-touch (auto) convenience for the window travel. Ideal for workshops and DIY mechanics who need a direct-fit unit identified by OEM codes 96652236XT / 6490AZ.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën C3 II (2009–2016)
- Product Codes: 96652236XT, 6490AZ
- Additional Numbers: Stellantis OEM References 96652236XT | 6490AZ
Function And Features
The unit consolidates the driver door’s electric window switches with the mirror adjustment joystick and the electric mirror fold/unfold command. The one-touch (auto) feature provides single-press window up/down convenience. The switch sends control signals to the window motors and mirror actuators via the vehicle wiring harness and on-board body electronics.
Common Failure Modes
- Wear Of Internal Contacts: Frequent use causes contact wear or loss of conductivity, leading to intermittent or non-functioning switches.
- Moisture And Contamination: Water ingress or spilled liquids in the door pocket area can corrode contacts and cause short circuits.
- Broken Connectors Or Wiring: Physical damage or corrosion in the connector pins or door harness (from repeated door opening/closing) can interrupt signals.
- Mechanical Damage: Broken actuator levers or cracked housing from impact or improper removal/installation.
How To Replace
- Safety First: Disconnect the negative battery terminal before starting work to avoid electrical shorts and unintended mirror/window movement.
- Remove Door Trim: Use plastic trim tools to detach the door card clips and carefully lift the panel away, starting at the bottom edge.
- Access Switch Module: Pry or unclip the switch bezel and remove any retaining screws or clips holding the switch assembly in place.
- Disconnect Electrical Connector: Depress the locking tab and pull the connector straight out. Inspect connector pins for corrosion or damage.
- Install New Switch: Plug in the new switch until the connector locks, seat the module, and reattach trim pieces in reverse order.
- Test Before Final Assembly: Reconnect the battery and verify window auto-up/down, mirror adjustment, and folding functions operate correctly before fully refitting the door card.
- Calibration Note: If one-touch functions or mirror fold behavior is abnormal after fitting, perform the manufacturer’s auto-calibration procedure for windows/mirrors if required.
Installation Recommendations
- Use Non-Marring Trim Tools To Avoid Damaging Clips And Door Trim.
- Check Wiring Harness For Chafing Or Exposed Wires And Repair As Needed Before Installing The New Switch.
- Apply A Small Amount Of Dielectric Grease To Connector Pins If Exposed To Moisture-Prone Environments.
- Test All Functions With The Door Open And Closed To Confirm Proper Operation And To Avoid Pinched Wires When Refitting The Door Card.
Why Replace This Part?
Replacing the driver door switch restores reliable window operation, mirror adjustment and folding functions—features used daily that influence comfort and safety. Timely replacement prevents further electrical strain on window motors and eliminates intermittent faults that can complicate diagnostics.
Search By Product Code: 96652236XT / 6490AZ — Keep These Codes Handy When Ordering Or Searching Catalogs.
