Description
Cable rod for the central locking mechanism of the left and right front door locks for PEUGEOT 307 vehicles.
This replacement door lock cable is a direct-fit solution for the front doors of the Peugeot 307. Designed for professional garages and experienced DIYers, it restores reliable central locking operation and prevents intermittent or non-functioning door locks. The part is listed under OEM reference 9151Y1 (Stellantis / Citroën Peugeot) and is commonly sought by its product code when repairing front door latch and handle linkages.
Technical information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Peugeot 307
- Product Codes: 9151Y1
- Other Numbers: 9151.Y1 (alternate OE formatting)
Function and Typical Symptoms
The cable rod transmits movement from the interior/exterior door handles and central locking actuator to the door latch. When the cable or its end fittings fail, common symptoms include: door not unlocking or locking from the handle, loose or disconnected-feeling handle, intermittent locking operation, or inability to open the door from inside or outside.
How To Replace
Replacement requires removal of the inner door trim and the moisture barrier to access the latch and linkage. Typical steps:
- Remove door trim fasteners and clips using appropriate trim tools to avoid damage.
- Peel back the moisture barrier carefully to reach the latch assembly.
- Disconnect the old cable from the interior/exterior handle and from the latch; unclip any retaining clips.
- Install the new cable, ensuring end fittings seat correctly and retaining clips are secure.
- Operate the handle and central locking to verify smooth movement before reassembling the door panel.
Recommended tools: trim removal tools, Phillips or Torx drivers (depending on vehicle trim), pliers. Apply light grease to pivot points if dry, but avoid contaminating door trim or electrical connectors.
Installation Recommendations
Fit the cable with care to avoid sharp bends or kinks that shorten service life. Make sure plastic end fittings are fully engaged and that retaining clips are replaced or secured. Test locking and unlocking several times with the door open to confirm correct routing and free travel. If the latch shows heavy corrosion or excessive wear, address the latch condition at the same time to prevent repeated failures.
Why This Part Fails Most Often
Failure is typically caused by long-term wear, water ingress and corrosion, or breakage of plastic end fittings and clips. Repeated heavy use, door impact, or a rusted latch that increases load on the linkage can accelerate failure. Lack of lubrication and exposure to road salt also contribute to premature wear.
Order using OEM code 9151Y1 to find the correct replacement for front left and right door central locking linkage on Peugeot 307 models.
