ESP Switch Citroën C4 96476624XT 454918

€10.00

Stellantis Citroën Peugeot
96476624XT 454918

5 in stock

SKU: 4682-N19_K25 Categories: , , ,

Description

ESP Switch For Citroën C4

Description

This ESP switch is intended for Citroën C4 vehicles and is a direct-fit control element used to operate the Electronic Stability Program (ESP/ESC) and related traction control functions. Designed with professional mechanics and skilled DIYers in mind, the switch features OEM reference numbers for quick identification during diagnosis and replacement. Clear markings and original-style connectors simplify installation and help restore proper vehicle stability system operation.

Why Choose This Part

Optimized for easy replacement on Citroën C4 models, this switch helps eliminate dashboard ESP/ASR faults caused by worn or damaged controls. Including the OEM codes in the listing increases findability for technicians searching by part number (96476624XT, 454918). The unit is suitable for routine repairs where the switch itself is the confirmed cause of loss of ESP control or erratic system behavior.

Technical Information

  • Manufacturer: Stellantis (Citroën/Peugeot)
  • Model: Citroën C4
  • Product Codes: 96476624XT, 454918
  • Other Numbers: Reference Numbers As Above

Installation Recommendations

Follow these practical steps for a safe and reliable replacement:

  • Disconnect The Battery Before Starting Work To Prevent Short Circuits And Protect Vehicle Electronics.
  • Remove The Required Trim Panels Or Center Console Inserts Using Trim Tools To Avoid Damage.
  • Unplug The Electrical Connector And Release Any Retaining Clips Or Fasteners Securing The Switch.
  • Install The New Switch By Reversing The Removal Steps, Ensuring Connectors Seat Firmly And Clips Engage.
  • After Reconnection Of The Battery, Verify Switch Operation And Confirm That No Fault Codes Remain. If ESP Warning Persists, Perform Further Diagnosis Of Wiring, Sensors, Or The ABS/ESP Control Module.

Most Common Failure Causes

  • Wear Of Internal Contacts From Frequent Use Leading To Intermittent Or Non-Functioning Switch Operation.
  • Moisture Ingress Or Corrosion At The Connector Causing Poor Electrical Contact.
  • Mechanical Damage From Impact Or Excessive Force During Removal/Operation.
  • Faults In Associated Wiring Or Ground Connections That Mimic Switch Failure.

Notes For Mechanics And DIYers

Always check The Part Number On The Existing Switch To Confirm Correct Match (96476624XT / 454918). Replacing The Switch Is A Common Repair When The ESP Light Remains Lit Or The System Won’t Engage/Disable Properly. If Fault Codes Persist After Replacement, Continue With Standard Diagnostic Procedures—inspect Wiring Harnesses, Ground Points And Related Sensors (Wheel Speed Sensors, Yaw Rate Sensor).

Practical Tips

  • Keep A Clean Work Area To Prevent Debris From Entering Connector Interfaces.
  • Use A Diagnostic Scanner To Clear Codes And Monitor System Status After Replacement.
  • Estimate Replacement Time: Approximately 15–45 Minutes Depending On Trim Removal Complexity.

Additional information

Weight 0.5 kg

Unless otherwise specified in the description, all photos are for illustrative purposes only.

We reserve the right to replace the ordered reference with the manufacturer's replacement reference.

The parts come from crashed vehicles, are carefully inspected, and we provide a 12-month warranty on functionality for them.