Description
Kinetic ESP Sensor TRW for Peugeot 407. Dual ESP Sensor.
High-quality TRW kinetic ESP sensor designed for Peugeot 407 vehicles. This dual ESP sensor provides the wheel speed/vehicle motion signals required by the ABS/ESP control unit to maintain stability and traction. Ideal for professional workshops and competent DIYers, the part restores correct operation of the electronic stability control system and helps extinguish ESP/ABS fault warnings when the original sensor is faulty. Commonly searched by part numbers, this unit is a direct-fit replacement for compatible Peugeot 407 models.
Technical Information
- Manufacturer: TRW
- Model: Peugeot 407
- Product Codes: 9645884180; 13665706; 454930
- Other Numbers: NFP
Compatibility
Fits Peugeot 407 models. Always verify the part numbers listed above against the vehicle’s existing sensor to ensure correct fitment.
Function And Symptoms Of Failure
The ESP sensor supplies the ABS/ESP control unit with crucial information about wheel speed and vehicle motion. When the sensor degrades or fails, the vehicle may display ESP or ABS warning lights, experience unstable braking modulation, or exhibit reduced traction/stability control intervention. Electrical faults, intermittent signals, or loss of communication with the control unit are typical fault symptoms.
Installation Recommendations
- Always disconnect the battery before starting work to avoid short circuits and protect vehicle electronics.
- Raise the vehicle safely and access the sensor location (typically located near the wheel hub or ABS unit depending on design).
- Disconnect the electrical connector and remove the mounting fasteners. Carefully extract the old sensor, avoiding damage to surrounding tone rings or wiring harnesses.
- Install the new sensor, secure mounting bolts and reconnect the electrical connector. Tighten fasteners to the manufacturer’s torque specification.
- After replacement, clear stored fault codes with a diagnostic tool and perform a road test to verify correct ESP/ABS operation. Some vehicles may require adaptation or calibration using a suitable diagnostic tool.
Most Common Reasons For Failure
- Water ingress and corrosion at the connector or sensor housing.
- Mechanical damage from impacts or wheel/hub service.
- Wiring harness wear, chafing or connector degradation causing intermittent signals.
- Contamination from road debris or metallic particles affecting the sensing element.
Additional Notes
Replacement sensors are often identified and purchased by their part numbers (9645884180, 13665706, 454930), so including these codes in searches increases the chance of a quick match. After installation, use diagnostic equipment to confirm that no fault codes remain and that the stability control system performs as expected.








