Peugeot 207 rear wiper motor 0390201813 9652418780

Description

Rear wiper motor for PEUGEOT 207 cars

Part description

Used rear wiper motor designed for Peugeot 207. It is an electrical component from the category of wiper mechanisms, which ensures the drive of the rear wiper and thus the correct function of wiping the rear window. Thanks to traceable part numbers, it is suitable as a replacement in the event of a malfunction of the original motor, when the wiper does not work, works irregularly or stops.

Technical information

• Manufacturer: Stellantis (CITROEN / PEUGEOT) / not specified
• Model: Peugeot 207
• Other numbers: 6405AN

Product codes

• Product codes: 0390201813, 9652418780

Installation recommendations

Generally/typically, the following procedure applies to replacing the rear wiper motor (exact steps may vary depending on the specific car model):

1) Before assembly

• Compare the part numbers from the tag/casting: 0390201813, 9652418780 and possibly 6405AN with the old piece.
• Check the connector(s): same shape, number of pins, undamaged securing.
• Inspect the motor body and the area around the output (shaft/axle): no cracks, no signs of leakage and significant corrosion.
• If a bearing surface/seal is included, check that it is clean and undamaged.

2) Necessary tools and materials

• Basic set of ratchets and extensions / keys
• Screwdrivers / torx bits (according to design)
• Plastic crowbar for removing upholstery/covers
• Contact cleaner (recommended), cloth
• Protective gloves

3) Step-by-step assembly procedure

1. Turn off the ignition and disconnect the battery for safety reasons.
2. Provide access to the rear wiper motor by removing the necessary internal covers/trimming at the mounting location (typically plastic parts – be careful not to break the mounts).
3. Disconnect the electrical connector from the engine – release the connector lock first.
4. Remove the engine fasteners (bolts/nuts depending on design).
5. Remove the original motor and check around the mount (cleanliness, traces of water, corrosion).
6. Clean the contact surface and possibly the connector/pins (contact cleaner should be used).
7. Install the used motor in its original position and fit the fasteners.
8. Tighten the fasteners adequately and evenly so that the motor fits properly and there is no tension.
9. Connect the electrical connector and verify proper snapping/locking.
10. Reinstall the removed covers/trims.
11. Connect the battery.

• 4) Post-assembly checks and test drive/function verification

  • Check that the rear wiper runs smoothly and does not stop.
  • Check for unusual noises (scratching, skipping) that may indicate a problem with the mechanism or attachment.
  • After a short drive/test, visually check the connector and motor mount again.

  5) The most common assembly mistakes + how to avoid them

  • Part swap by appearance – always compare numbers 0390201813 / 9652418780 (and 6405AN if listed).
  • Not clicked connector – leads to outages; check the arrest after connecting.
  • Damage to the plastic cover handles – use a plastic pry bar and proceed without violence.

  Reasons why the part is damaged

  • Leakage and moisture in the engine compartment – corrosion, oxidation of connectors and internal engine damage.
  • Mechanical overload (stuttering of the mechanism, increased wiper resistance) – the engine overheats and its service life is shortened.
  • Wear due to age and frequent use.
  • Electrical problems (increased transient resistance in connectors, damaged wiring) – erratic operation and overheating.