Description
Steering column controls, COM2008P stalks for Citroën C4 II, Peugeot 508, DS4 and DS5. They operate the lights, fog lights, front and rear wipers, indicators, horn and trip computer.
High-quality replacement steering column stalk assembly designed for professional workshops and experienced DIY mechanics. The COM2008P stalks restore full multifunction control behind the steering wheel, delivering precise switching for lighting, wipers and signalling circuits. Built to match the original fitment for Stellantis Group models, this unit is ideal when the original stalk shows intermittent operation, mechanical play or electrical faults. Many technicians and car owners search by product codes (COM2008P, 96759252XT, 6243C6) to find an exact match quickly.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot / DS)
- Model: Citroën C4 II, Peugeot 508, DS4, DS5
- Product Codes: COM2008P, 96759252XT, 6243C6
- Additional Numbers: 96759252 XT (alternative formatting observed in parts lists)
Installation Recommendations
Replacement of a steering column stalk typically includes the following steps. These are general guidelines; always follow the vehicle manufacturer procedure and safety rules:
- Disconnect the battery and wait the recommended time to allow SRS capacitors to discharge.
- Remove the steering wheel airbag and steering wheel if required by the vehicle design (follow manufacturer instructions).
- Remove the steering column shrouds to access the stalk mounting screws and electrical connector.
- Unplug the electrical connector, release the retaining clips and remove the old stalk assembly.
- Fit the new stalk, reconnect the wiring, reassemble shrouds and steering wheel components, then reconnect the battery.
- Verify all functions (lights, indicators, wipers, horn, trip computer) before returning the vehicle to service.
Due to airbag and steering system safety, installation is recommended for qualified technicians or experienced DIYers who are familiar with SRS procedures.
Why This Part Fails Most Often
- Electrical Contact Wear: Frequent use leads to degraded contacts and intermittent signals for lights or wipers.
- Moisture Ingress And Corrosion: Water or humidity can corrode connectors and internal switch contacts.
- Mechanical Fatigue: Repeated movement causes internal plastic or spring components to wear or break.
- Short Circuits Or Overloads: Faults in connected circuits (e.g., lamps or motors) can damage switch electronics.
Part Searches: Customers commonly search using the product numbers COM2008P, 96759252XT and 6243C6 to locate the correct replacement quickly. This unit is supplied as a direct-fit replacement for the listed models and restores original functionality when fitted correctly.
