Description
Delphi COM2000 stalk switches located under the steering wheel for Citroën and Peugeot vehicles. They control fog lights, the trip computer, rear wiper, ESP, cruise control and car radio (the stalk must be supplied or transferred).
Designed for professional workshops and experienced DIY mechanics, this Delphi COM2000 multifunction stalk is a direct-fit solution for a range of Citroën and Peugeot models. It consolidates several controls on the steering column for convenient operation and restores full vehicle functionality when a failed stalk causes loss of commands. Because these parts are frequently searched by OE numbers, the correct product code is shown below to help you find the right replacement quickly.
Technical Information
- Manufacturer: Delphi / Stellantis (Citroën, Peugeot)
- Model: Citroën Berlingo II, Citroën C5 I, Citroën C8, Citroën Xsara, Citroën Xsara Picasso; Peugeot 206, Peugeot 307 I, Peugeot 406, Peugeot 807, Peugeot Partner II
- Product Codes: 96574694XT, 6242C5
- Other Numbers: 96595089XT, 96605654XT, 624219, 6239AN, 6239M4, 6239PY, 6239W3, 6239X7
Installation Recommendations
- Always disconnect the battery before starting work to prevent short circuits and protect vehicle electronics.
- Remove the steering column trim panels to access the stalk assembly. Panels are normally secured by clips and a few screws (Torx or Phillips depending on the model).
- Unplug electrical connectors carefully—avoid pulling on wiring. If radio or other controls are separate, transfer them to the replacement stalk as required.
- Fit the new stalk into the column and secure fasteners to the manufacturer’s recommended specifications. Reconnect connectors and the battery.
- Verify All Functions After Installation: Test fog lights, trip computer functions, rear wiper, ESP signals, cruise control operation and radio controls before reassembling trims.
- Use Appropriate Tools And Care: Avoid forcing plastic clips or overtightening screws to prevent damage to the steering column covers and the new stalk.
Why This Part Fails Most Often
- Wear Of Internal Contacts Caused By Frequent Use Leading To Intermittent Or Lost Functions.
- Mechanical Damage To The Lever Or Pivot From Impact Or Excessive Force.
- Moisture Ingress And Corrosion Affecting Connectors And Internal Switches, Especially In Older Vehicles.
- Electrical Problems Such As Short Circuits Or Wiring Harness Damage That Prevent Proper Signal Transmission.
Practical Tips For Diagnostics
- Inspect For Visible Damage And Loose Connectors First.
- Use A Multimeter To Check Continuity Of Switch Circuits While Operating The Stalk.
- Clean Corroded Pins With Suitable Electronic Cleaner And Ensure Connectors Seat Firmly.
- Compare Part Numbers And Connector Pinouts To Confirm Compatibility Before Fitting.
Ordering Note: This multifunction Delphi COM2000 stalk is commonly referenced by the OE numbers above. Use those codes when searching to ensure correct fitment for your Citroën or Peugeot.
