Description
Steering Column Stalks, Multifunction Stalk DELPHI COM2003 For Citroën And PEUGEOT Vehicles. Controls Fog Lights, Trip Computer, Front And Rear Wipers, Wiper Sensor, ESP, Cruise Control And Car Radio (Stalk Must Be Supplied Or Transferred).
High-quality replacement multifunction stalk designed for Citroën and Peugeot steering columns. This unit covers the most common steering-wheel control functions—wipers (front and rear), rain sensor interface, fog lights, trip computer controls, ESP interface, cruise control inputs and steering-wheel radio controls (radio controls may need to be transferred from the original stalk). Frequently searched by product codes 96567445XT and 6242A4, this part is suitable for workshops and DIY mechanics who need a reliable, direct-fit solution for steering column faults.
Technical Information
- Manufacturer: Delphi / Stellantis (Citroën, Peugeot)
- Model: Multifunction Stalk COM2003 — Compatible With Selected Citroën And Peugeot Models
- Product Codes: 96567445XT, 6242A4
- Additional Numbers: DELPHI COM2003, NFP
Compatible Models
Commonly Fitment Includes: Peugeot 206, Peugeot 307 II, Peugeot 406, Peugeot 807, Citroën Berlingo II, Citroën C5 I, Citroën C8. Check the stamped/printed product codes to confirm physical match. The part is often located and ordered by its product number (96567445XT / 6242A4).
Installation Recommendations
Installation should be performed by a trained technician or an experienced DIYer with basic tools. General replacement steps:
- Disconnect The Battery: Always disconnect the negative terminal and wait the recommended time to allow restraint systems to discharge before starting work.
- Remove Steering-Column Covers: Remove screws and carefully separate upper and lower covers to access the stalk assemblies.
- Unplug Electrical Connectors: Release any retaining clips and unplug the stalk wiring harness. Note the connector orientation and locking tabs.
- Remove The Old Stalk: Unscrew or unclip the stalk from the steering column. If radio or cruise-control buttons are integrated and required, prepare to transfer them to the replacement stalk if not included.
- Fit The New Unit: Secure the new stalk in position, reconnect connectors and clamps, and reassemble the steering-column covers.
- Function Check: Reconnect the battery and verify all functions—wipers (including intermittent and rain-sensor response), fog lights, trip computer inputs, ESP warning behavior, cruise control engagement and radio controls—before final road testing.
Note: If Radio Or Cruise-Control Buttons Are Not Part Of The Supplied Unit, They Must Be Transferred From The Original Stalk Or Supplied Separately.
Most Common Failure Reasons
Multifunction stalks typically fail due to mechanical wear and electrical contact degradation. Common causes include:
- Contact Oxidation Or Wear: Frequent use causes contacts to become intermittent or fail completely, producing lost or erratic functions.
- Mechanical Breakage: Plastic detents, levers or mounting points can crack after years of use or impact to the steering column.
- Moisture Ingress Or Contamination: Water or dirt penetrating the switch assembly leads to corrosion and electrical shorts.
- Faults In Integrated Controls: Buttons for radio or cruise control can wear out or have poor solder joints on the PCB inside the stalk.
Why Choose This Unit
This multifunction stalk offers a practical, cost-effective repair for common steering-column control faults on many Citroën and Peugeot models. With clear product codes for ordering and straightforward replacement steps, it reduces workshop time and restores full steering-column functionality when original controls become unreliable.
Additional Notes
Because steering-column work can affect airbags and vehicle electronics, follow manufacturer safety procedures during disassembly and reassembly. If radio or cruise-control functions are integrated, ensure button modules are present or plan for transferring them from the original stalk.
