Description
Tachometer for PEUGEOT 307 vehicles. From a vehicle with approximately 163,000 km.
Product Overview
This original instrument cluster (speedometer / tachometer assembly) is a direct-fit unit removed from a Peugeot 307. It is ideal for professional workshops and experienced DIY mechanics looking to replace a faulty cluster or restore accurate vehicle instrumentation. The unit carries manufacturer product codes commonly searched by buyers, increasing the chance of quick identification and fitment.
Key Benefits
- Direct fit for Peugeot 307 (Phase 1 & Phase 2) applications
- OEM part numbers included to simplify parts lookup and ordering
- Complete instrument cluster ready for installation — speedometer, tachometer and associated indicators
- Suitable for mechanics and competent DIY installers familiar with dashboard electronics
Compatibility
Designed for Peugeot 307 models (both Phase 1 and Phase 2). Before purchase, compare the part numbers listed below with the unit being replaced to ensure correct match.
Installation
Typical replacement steps for instrument cluster swap (general guidance):
- Disconnect the negative battery terminal and wait a few minutes to ensure vehicle systems are powered down.
- Remove instrument cluster trim and any surrounding panels (retain fasteners).
- Unscrew the cluster mounting screws and carefully pull the cluster forward to access connectors.
- Unplug electrical connectors by releasing locking tabs—avoid pulling on wiring.
- Install the replacement cluster by reversing removal steps, reconnect connectors and refit trim.
- After installation, switch ignition to ON and verify the instrument self-test and all warning lights/needles operate correctly.
Common Symptoms Indicating Replacement
- Needles stuck, jittery or not returning to zero
- Partial or total loss of speedometer or rev counter
- Dim or non-functional backlighting and indicator lamps
- Intermittent operation caused by poor electrical contact at connectors
Technical Information
- Manufacturer: Stellantis (Peugeot / Citroën)
- Model: Peugeot 307 (Phase 1 & Phase 2)
- Product Codes: 9655476580, G00 9655476580, 6105KS
- Other Numbers: Common OEM references may match the codes above; confirm visually on the original unit
Installation Recommendations
Always disconnect the battery before starting work on dashboard electronics. Handle the cluster and connectors carefully to avoid damage to plastic tabs and printed circuit board traces. Use hand tools and avoid excessive force. If you are not experienced with vehicle electrical systems, consider having the installation performed by a qualified technician.
Why This Part Fails Most Often
Instrument clusters commonly develop faults due to the following causes:
- Wear of internal stepper motors or mechanical linkages that drive needle movement.
- Cracked solder joints or broken traces on the printed circuit board caused by vibration and thermal cycling.
- Moisture ingress or connector corrosion leading to intermittent electrical contact.
- Failure of backlight LEDs or internal voltage regulation components.
Purchase Notes
This listing contains an original cluster removed from a Peugeot 307 with approximately 163,000 km. Check the product codes above against your original unit to confirm match. Suitable for professional replacement or for experienced DIY mechanics familiar with dashboard removal and electrical reconnection.
