Description
Airbag for the right seat cushion for Citroën C5 I and II
Color HZW – Matinal Grey
Passenger seat cushion
High-quality replacement side airbag designed for the passenger seat cushion of Citroën C5 first and second generation. This unit restores side-impact protection for the pelvis and thorax area and is often searched by its OEM codes — ideal for professional workshops and experienced DIY mechanics who service Stellantis vehicles. The part fits directly into the seat cushion and is intended as a direct-fit component for vehicles specified below.
Key Benefits
Provides original safety function for side impact protection. Direct-fit design for easy replacement in the seat cushion. Commonly referenced by product codes, making it easy to find and order by part number. Suitable for technicians who have experience with SRS components and basic seat disassembly.
Technical Information
- Manufacturer: Citroën (Stellantis)
- Model: Citroën C5 I, Citroën C5 II (Passenger Seat)
- Product Codes: 96541529ZW
- Additional Numbers: 96391352ZW, 8216GZ
Function And Typical Failure Modes
The side airbag in the seat cushion inflates in a side-impact event to protect the occupant’s pelvis and thorax. It is normally triggered by crash sensors and the vehicle’s SRS control unit. Typical reasons for replacement include:
- Deployment during a collision (one-time use — must be replaced after activation).
- Electrical faults such as damaged seat wiring, broken connector pins or corroded contacts causing an SRS warning lamp.
- Water ingress or prolonged moisture leading to connector corrosion or internal damage.
- Physical damage to the seat cover or mounting caused by wear, repair work or aftermarket modifications.
How The Part Is Replaced
Replacement requires careful handling of SRS components. Typical procedure:
- Disconnect the negative battery terminal and wait at least 10 minutes to allow the SRS system capacitors to discharge.
- Recline or remove the seat to gain access to the cushion fasteners and trim clips.
- Carefully remove seat trim and foam where required to expose the airbag module connection and mounting points.
- Unplug electrical connectors (avoid pulling on wires) and unbolt the airbag module from the cushion.
- Install the new airbag, reconnect connectors securely, reassemble seat trim and refit the seat to the vehicle using original fasteners and manufacturer’s torque values.
- Clear SRS fault codes and confirm system readiness with a diagnostic scanner. Verify that the airbag warning lamp behaves normally during ignition.
Installation Recommendations
- Always disconnect the battery before starting work on SRS components and follow manufacturer safety procedures.
- Handle the airbag module carefully — avoid impact, heat sources and static discharge.
- Use correct tools and observe manufacturer torque values for seat and airbag mounting bolts.
- After installation, use an appropriate diagnostic tool to read and clear SRS codes and confirm the system is OK before returning the vehicle to service.
- If any wiring or connector damage is found, repair or replace wiring harness sections to restore reliable connectivity.
Why This Part Is Often Searched By Code
Airbag modules and seat components are commonly referenced by OEM part numbers (e.g., 96541529ZW). Searching by code ensures correct match to seat trim, connector type and mounting variant across Citroën C5 I and II variants, so technicians frequently use the part number when ordering replacements.
Suitable For
Professional automotive technicians, bodyshop technicians and experienced DIY mechanics working on Citroën C5 I and II passenger seats who require a direct-fit side airbag module identified by the attached OEM numbers.
