Description
Electric central locking latch for the right front passenger door. For Peugeot 3008 and 5008 first series. Passenger door.
Product Description
This electric central locking latch is a direct-fit replacement for the right front (passenger) door on first-generation Peugeot 3008 and 5008 models. Designed for workshop use and DIY repairs, the unit restores reliable locking, unlocking and secure door closure via the vehicle’s central locking system. Frequently searched by OE numbers, this part is commonly listed under the referenced product codes and is compatible with the standard mechanical linkages and electrical connector used on the original assemblies.
Key Benefits
- Direct fit for right front passenger door on Peugeot 3008 I and 5008 I.
- Restores central locking functionality and door latching security.
- Suitable for professional garages and competent DIY mechanics.
- Often identified and ordered by OE/product numbers for quick replacement.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Peugeot 3008 I, Peugeot 5008 I — Right Front (Passenger) Door
- Product Codes: 9800623080, 9136GC
- Additional Numbers: 9138V4
Compatibility And Fitment
Fits first‑generation Peugeot 3008 and 5008 vehicles where the right front (passenger) door uses the same latch assembly and electrical connector pattern. This part replaces the internal latch/actuator unit and mounts in the original location with the factory linkage. Always confirm the part numbers listed on the unit match the numbers shown above when possible.
How To Replace
Replacement requires basic door disassembly and electrical handling skills. Typical procedure:
- Remove the interior door trim panel to access the latch assembly (carefully release retaining clips and remove any screws).
- Disconnect the electrical connector(s) to the latch actuator and any door module connectors.
- Support and unhook mechanical linkages (rods/cables) for the door handle and lock mechanism; note routing and orientation for reassembly.
- Unscrew and remove the latch assembly from the door shell.
- Install the new latch, reconnect linkages and electrical connector(s), then test functionality before reassembling the door trim.
- Reassemble the door trim, ensuring clips and fasteners are secure. Verify central locking, manual locks, and door opening/closing operation.
Installation Recommendation
- Disconnect the negative battery terminal before starting work to avoid short circuits and unintended actuator operation.
- Keep fasteners, clips and linkage pins organized for correct reassembly.
- Use gentle lubrication on mechanical sliding parts and check for any bent linkages or corrosion in the door cavity.
- If the original unit is damaged by impact or corrosion, replacement of the complete latch assembly is recommended rather than partial repair.
- After installation, check central locking operation from both the key/remote and the interior switch; confirm door closes and seals correctly.
Most Common Failure Reasons
- Wear of internal plastic gears or actuator motor leading to loss of movement.
- Water ingress and corrosion inside the latch assembly, especially where door seals or drainage are compromised.
- Broken or bent mechanical linkages and rods caused by forceful operation or door impact.
- Electrical connector corrosion or intermittent contacts causing unreliable locking signals.
Notes For Buyers
Mechanics and experienced DIYers often search by OE/product numbers (9800623080, 9136GC, 9138V4) to ensure correct fitment. This description focuses on fitment for the right front passenger door of first‑generation Peugeot 3008 and 5008 models and provides practical guidance for replacement and troubleshooting.
