Description
Window regulator mechanism for the right rear window for PEUGEOT 308 T7
Passenger-side rear door
High-quality replacement electric window regulator mechanism designed for the right rear (passenger-side) door of the Peugeot 308 (T7). This part restores smooth and reliable operation of the power window system, eliminating symptoms such as slow or jerky movement, rattling inside the door, or a window that will not stay in position. Commonly searched by OEM numbers, this unit is suitable for professional workshops and competent DIY mechanics who maintain or repair Peugeot 308 vehicles.
Key Benefits
– Direct fit for the right rear door of Peugeot 308 (T7).
– Restores factory-like window movement and sealing.
– Reduces the risk of further damage to window glass and door internals caused by a failing regulator.
– Often found by product codes (see Technical Information).
Application And Function
The window regulator mechanism converts the rotary motion of the electric motor (power window motor) into linear movement to raise and lower the rear right window pane. It guides the glass along the door track and keeps it correctly aligned with the door frame and seals. A properly working regulator prevents wind noise, water ingress, and excessive wear on the motor and glass mounting points.
Technical Information
- Manufacturer: Peugeot / Stellantis
- Model: Peugeot 308 (T7)
- Product Codes: 9675462980, 9675462980-00, 9224E2
- Other Numbers: 9675462980 (alternate formatting), 9224E2
Installation Recommendations
- Park the vehicle on a level surface, switch off the ignition and disconnect the negative terminal of the battery before starting work.
- Remove the inner door trim and any water/vapor barrier carefully to avoid tearing. Keep all fasteners and clips for reassembly or replace damaged clips.
- Support the window glass in the up position (tape or suction cups) before detaching the regulator from the glass.
- Disconnect the electrical connector to the window motor and unbolt the regulator assembly from the door shell.
- Fit the new regulator, securing it to the door and glass, then reconnect the motor connector. Check that the glass runs freely in the tracks before final tightening.
- Test full window travel and auto-reverse functions (if applicable) before refitting the door trim. Adjust glass alignment if necessary to ensure proper sealing and smooth operation.
- Use appropriate lubricants on sliding tracks and inspect cables, guides and seals during the job. Replace damaged seals to prevent water ingress.
Why This Part Fails
Window regulator mechanisms commonly fail due to normal mechanical wear and environmental factors. Typical causes include:
- Worn or stretched cables and frayed cable bindings that prevent smooth movement.
- Broken or cracked plastic sliders and guides that detach from the track.
- Motor overload or burnout caused by excessive friction from corroded tracks, damaged seals or misaligned glass.
- Water ingress and corrosion inside the door leading to seized components or electrical faults.
- Impacts or forced operation (e.g., closing with an obstruction) that bend rails or damage mounting points.
Notes For Purchase
Search by OEM numbers (9675462980 / 9675462980-00 / 9224E2) to increase the chance of finding the correct match. The part is intended for the right rear (passenger-side) door of the Peugeot 308 T7 — confirm door location and product code before installation. Suitable for professional fitting or experienced DIY mechanics familiar with door trim removal and window alignment procedures.
