Description
Product Overview
High-quality ATE ABS/ESP pump assembly supplied with a partial wiring harness for Citroën C5 II. This module controls hydraulic brake pressure to support ABS and ESP interventions and is often identified by multiple part numbers. The information below helps confirm fitment and identify the correct replacement for workshop or DIY use.
Features & Benefits
- Direct fit for compatible Citroën C5 II applications, streamlining replacement for professional mechanics and competent DIYers.
- Includes a section of the wiring harness to simplify electrical reconnection and minimize additional wiring work.
- Restores correct ABS/ESP hydraulic modulation by managing brake pressure and enabling vehicle stability control interventions.
- Useful when diagnosing ABS/ESP fault codes or replacing failed pump or valve block components.
Technical Information
- Manufacturer: ATE
- Model: Citroën C5 II (2006) 2.0 HDi RHR Estate
- Product Codes: 10.0960-1147.3, 10.0206-0189.4
- Other Numbers: 9657061080, 4541F0, 4542F0, 4542F1, 4541G1, 4541G2
Fitment & Compatibility
Compatible with Citroën C5 II vehicles, commonly found on second-generation C5 models with the 2.0 HDi (RHR) engine. Always verify the vehicle VIN and the part number on the existing unit before ordering; many technicians search by the part numbers listed above to ensure correct match.
Replacement Guide
Typical replacement steps: disconnect the battery, record ABS fault codes, safely raise the vehicle, drain brake fluid, label and disconnect brake lines and electrical connectors, unbolt and remove the pump assembly. Fit the replacement unit, reconnect lines and harness, refill and bleed the brake system, then clear fault codes and perform a road test. Use correct tools, follow safety procedures and observe manufacturer torque settings where applicable.
Common Causes Of Failure
Failures are often caused by corrosion or water ingress, seized pump motor or valves, internal hydraulic wear, or electrical faults at connectors or the control circuitry. Warning signs include ABS/ESP warning lamps, abnormal pump noise, a spongy brake pedal, or loss of traction control functions.
Notes
This listing references multiple part numbers shown above. Some variants (for example 4541G1 / 4541G2) are commonly associated with hydraulic block-only configurations without the electronic control unit; confirm the exact configuration with the supplier before purchasing.
