Description
Electric window regulator for PEUGEOT 3008 and 5008 first generation. Rear passenger side.
High-quality electric window regulator motor designed as a direct replacement for the rear passenger side window of Peugeot 3008 and 5008 (first generation). Ideal for workshops and experienced DIY mechanics who need a reliable, fast-fitting spare part. The unit restores smooth and quiet window travel, eliminates intermittent operation and prevents the window from slipping or jamming. Commonly sought by OEM part numbers, this spare part improves service turnaround and ensures correct fitment without modifications.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 3008 I, Peugeot 5008 I
- Product Codes: 9682808680, 1607674980
- Additional Numbers: 9224F6
Compatibility
This electric window regulator motor is compatible with first-generation Peugeot 3008 and 5008 models for the rear passenger side. Verify the part numbers listed above against the vehicle’s existing component to ensure correct match and fitment.
Function
The unit contains an electric motor coupled to the window regulator mechanism that raises and lowers the rear passenger window. It converts the rotary motion of the motor into controlled linear motion of the glass, enabling operation from the door switch. Proper operation guarantees secure sealing, smooth travel and correct adjustment of the window position.
Common Causes Of Failure
Window motors and regulators typically fail due to one or more of the following reasons:
- Wear Of Motor Brushes Or Commutator Resulting In Intermittent Operation
- Mechanical Wear Of Gears Or Cable/Slider Components Causing Slippage Or Jamming
- Water Or Moisture Ingress Leading To Corrosion And Electrical Faults
- Physical Damage From Impact Or Forcing The Window (Obstruction / Misalignment)
- Worn Guide Rails Or Damaged Window Clips Increasing Load On The Motor
Replacement Procedure (Overview)
Designed for technicians and competent DIYers. Typical replacement steps:
- Disconnect The Battery Before Starting Work To Avoid Short Circuits And Unintended Operation.
- Remove Door Trim And Insulation Carefully To Access The Regulator Assembly.
- Support The Window Glass (Tape Or Suction Support) And Detach The Glass From The Regulator.
- Disconnect The Electrical Connector To The Motor.
- Unbolt And Remove The Old Regulator/Motor Assembly.
- Install The New Unit, Reattach The Glass, Reconnect The Electrical Connector And Test Operation Before Reassembling The Door Trim.
- Check Window Alignment And Smooth Movement; Lubricate Guide Channels If Necessary.
Installation Recommendations
Always follow manufacturer service procedures and use appropriate tools. Disconnecting the battery is recommended before removal and installation to prevent electrical damage. When installing, check door wiring for corrosion, ensure connectors are clean and secure, and verify that the window tracks and clips are in good condition. Test full up/down cycles and the switch operation before final assembly of the door panel.
Why Replace This Part?
Replacing a failing window regulator motor restores reliable window operation, improves cabin comfort and prevents further damage to the door mechanism caused by continued use of a worn unit. Changing the complete regulator with motor is usually more time-efficient and durable than attempting partial repairs.
Part numbers listed match commonly used OEM references for the described models — choose this unit when you need a direct-fit replacement for the rear passenger side window of Peugeot 3008/5008 first generation.
