Description
Side Airbag For Left Seat CITROËN C5 I And II
Color HZW – Gray Matinal
Without Wiring
Driver Seat
High-quality replacement side airbag module designed for the left (driver) seat of Citroën C5 first and second generation. Supplied without the seat harness, this unit matches original equipment part numbers used on numerous Stellantis vehicles and is ideal for professional workshops and experienced DIY mechanics restoring SRS safety functionality after an incident or seat refurbishment. The airbag cushion and inflator assembly provide lateral thorax and pelvis protection in side-impact events and are manufactured to fit the original seat cavities and mounting points.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën C5 I, Citroën C5 II
- Product Codes: 96541528ZW
- Additional Numbers: 96358187ZW, 8216GN, NFP
- Color: HZW – Gray Matinal
- Configuration: Left Side, Driver Seat, Supplied Without Wiring Harness
Function And Application
The side airbag is an integral part of the vehicle SRS (Supplemental Restraint System). It deploys in moderate to severe side impacts to reduce injury to the occupant’s chest and pelvis by absorbing and distributing crash forces. This specific unit is intended for installation in the left/front seat of Citroën C5 I and II models and fits the factory seat structure and trim cavities where original airbags are mounted.
Replacement Procedure (Overview)
Only for trained technicians or experienced DIY mechanics. Typical replacement steps:
- Park the vehicle on a level surface, engage the parking brake and remove the ignition key.
- Disconnect the negative battery terminal and wait at least 10 minutes to allow the SRS capacitors to discharge.
- Remove the seat trim and any plastic covers to access the airbag module retaining screws/clips. Carefully note connector routing and fastener locations.
- Unplug the airbag connector(s) using the correct release tool; inspect for damage or corrosion.
- Unbolt and remove the defective airbag module; install the replacement in the original orientation and torque fasteners to manufacturer specifications.
- Reconnect the airbag connector(s) and reassemble trim. Reconnect the battery.
- Clear SRS fault codes and run an SRS system check with a compatible diagnostic tool (PSA DiagBox/Lexia or equivalent capable of handling SRS functions).
Installation Recommendations
- Always disconnect the battery and wait the recommended time before starting work to avoid accidental deployment.
- Use correct tools and follow the vehicle manufacturer’s instructions for seat and airbag removal to prevent damage to clips, bolts and trim.
- Inspect wiring, seat harnesses and connectors for abrasion, corrosion or previous repair. Replace damaged harnesses rather than attempting makeshift repairs.
- After installation, perform a full SRS diagnostic and confirm no residual fault codes remain. Use a diagnostic tool capable of SRS functions for accurate reset and verification.
Why This Part Fails Most Often
Common causes for side airbag replacement include deployment during a collision, damage to the airbag connector or wiring (often from seat removal or seat rail movement), deterioration of harness insulation, and physical damage to the module or inflator. Moisture ingress or corrosion in connectors can produce SRS faults. In many cases the airbag cushion itself is intact but the system must be repaired following an impact or if safety-related wiring has been compromised.
Notes For Buyers
- Part is supplied without wiring harness; ensure you have the correct seat harness or replacement connectors when fitting.
- There is no fixed service life for airbag modules; replacement is required after deployment or when the module or connectors are damaged.
- For proper SRS function verification, use of a diagnostic tool with SRS capability is recommended after installation.
