Description
Left front wiper motor for Peugeot 3008 and 5008 first generation. Driver’s side.
This high-quality replacement left front (driver’s side) wiper motor is designed for first generation Peugeot 3008 and 5008 models. Ideal for professional workshops and DIY mechanics, the unit restores reliable windshield wiping performance and park positioning. Commonly searched under part numbers 9671062180, 3397021288, 6405PZ and 6405QA, this motor fits original mounting points and electrical connectors for a straightforward swap. Suitable for repairing intermittent or non-working wipers caused by motor failure, excessive play in the gearbox or corrosion of electrical contacts.
Technical Information
Manufacturer: Stellantis (Citroën/Peugeot)
Model: Peugeot 3008 I (first generation), Peugeot 5008 I (first generation)
Product Codes: 9671062180, 3397021288, 6405PZ, 6405QA
Other Numbers: Common OE cross-references used in parts listings
Function And Symptoms
The wiper motor provides the torque to drive the linkage that moves the front wiper arms and ensures correct park position when switched off. Typical symptoms of a failing motor include no movement at all, slow or jerky wiping, wipers stopping in the wrong position, or unusual noise from the cowl area. In many cases, the motor still runs but the internal gearbox or brushes have worn, causing loss of drive to the linkage.
Replacement Procedure (Overview)
1) Switch off ignition and remove the key. It is recommended to disconnect the battery to avoid accidental activation.
2) Mark the wiper arm positions relative to the windshield to preserve park alignment.
3) Remove the wiper arms (usually by lifting the cap and undoing the retaining nut) and the cowl/plastic trim to access the motor assembly.
4) Disconnect the electrical connector and unbolt the motor from the linkage/cowl.
5) Remove the motor from the linkage (note orientation and any shims) and install the new unit in reverse order.
6) Refit the cowl and wiper arms, set them to the marked positions, reconnect the battery and test full wipe and park functions.
Installation Recommendations
– Always secure the wiper arms’ park position before removal to avoid incorrect rest position after installation.
– Check the linkage and pivots for excessive play or seized joints; replace or lubricate as needed to prevent premature wear of the new motor.
– Inspect the electrical connector for corrosion; clean contacts and apply dielectric grease to improve long-term reliability.
– Tighten mounting bolts to manufacturer torque where specified and ensure the motor engages the linkage correctly before final assembly.
– After installation, verify wipe speed, sweep range and correct parking by performing several wipe cycles with the ignition on.
Why It Most Commonly Fails
Wiper motors on these models typically fail due to a combination of factors: water ingress and corrosion from cowl drainage, worn brushes or commutator inside the motor, mechanical wear in the gearbox or splined output shaft, and strain from frozen or obstructed wiper linkages. Heavy or frequent use, exposure to road salts and debris, and neglected linkage lubrication accelerate wear.
Suitable For
Peugeot 3008 I (first generation) and Peugeot 5008 I (first generation) front left (driver side) wiper motor replacements. Frequently listed under OE codes 9671062180, 3397021288, 6405PZ, 6405QA—enter these numbers when searching to find matching listings.
