Description
Left rear lamp for Citroën C1, may also fit Peugeot 107
Driver’s side
Without bulb sockets
Original part
Overview
OEM Left Rear Lamp for Citroën C1 (possible fitment to Peugeot 107) supplied as an original equipment part. Ideal for professional workshops and DIY enthusiasts looking for a direct-replacement tail lamp assembly. Supplied without bulb sockets, so bulbs and holders must be reused from the original unit or purchased separately. Commonly searched by product numbers 81560-0H060 and 6350X8.
Technical Information
- Manufacturer: Stellantis
- Model: Citroën C1 / Peugeot 107
- Product Codes: 81560-0H060, 6350X8
- Additional Numbers: OEM Reference 81560-0H060 / 6350X8
Fitment And Function
Designed for the left rear (driver’s side) of Citroën C1 models and commonly compatible with Peugeot 107 variants. The assembly houses the tail and brake light circuits and—depending on vehicle specification—may accommodate turn signal and reverse lamp functions. Check the lamp connector shape and mounting points against the original unit to confirm fitment.
Replacement Guide
Typical replacement steps for a left rear lamp assembly:
- Open the boot and remove the interior trim panel or access cover to reach the lamp fixing nuts.
- Unscrew the retaining nuts or bolts and carefully pull the lamp assembly outward from the body.
- Disconnect the wiring harness from the lamp. If the new lamp is supplied without bulb sockets, transfer bulbs and socket holders from the old lamp or install new sockets/bulbs.
- Position the new lamp assembly, reconnect the wiring harness and secure with the original nuts/bolts.
- Refit the interior trim and test all light functions (tail, brake, indicators, reverse where applicable).
Installation Recommendations
- Work In A Dry Environment To Avoid Contaminating Connectors And Seal Areas.
- If Bulb Sockets Are Reused, Inspect For Corrosion Or Melt Damage And Replace If Needed.
- Ensure The Lamp Seal Sits Correctly Against The Body To Prevent Water Ingress.
- After Installation, Verify All Light Functions And Adjust Alignment If Required.
Why This Part Fails Most Often
- Collision Damage: Rear impacts and parking bumps commonly crack the lens or damage the mounting points.
- Water Ingress: Failed seals or cracks allow moisture in, causing corrosion of contacts and bulb failure or short circuits.
- Connector Corrosion: Oxidation At The Electrical Connector Can Disrupt Lighting Circuits.
- Heat Damage From Bulb Or Poor Ventilation: Overheated sockets may deform or melt plastic components.
Notes For Professionals And DIYers
This lamp is an OEM-style replacement intended to restore original fit and appearance. Because it is supplied without bulb sockets, plan to transfer functioning sockets and bulbs from the original assembly or order compatible sockets and bulbs separately. Always test all lighting functions after installation and ensure the lamp is sealed correctly to prevent premature failure.
