Description
Interior Door Handle For Right Front And Right Rear Doors For Citroën C4 And Peugeot 407. Color FVD – Gray Chrome.
Product Overview
Premium replacement interior door handle designed for the right front and right rear doors of Citroën C4 and Peugeot 407 models. This handle restores proper opening function and original appearance where the factory handle is cracked, worn or the internal lever has failed. Frequently searched by mechanics and DIY enthusiasts under original part numbers, this unit is a practical direct-fit option for body repairs and interior refurbishment.
Key Benefits
- Direct Fit Replacement: Designed to match OE mounting points and linkage connection for straightforward installation.
- Durable Finish: Gray Chrome surface that blends with factory interior trim.
- Cost-Effective Repair: Replace only the failed handle instead of the full door module or trim assembly.
- Suitable For Professionals And DIYers: Clear installation steps and common tools make this part practical for workshops and home repairs.
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Citroën C4; Peugeot 407
- Product Codes: 96435310VD, 96526177VD
- Other Numbers: 914493
Fitment And Application
Fits right-side interior doors (right front and right rear) of Citroën C4 and Peugeot 407 models. Ideal for vehicles with broken plastic tabs, worn levers or cosmetic surface damage on the inner pull handle.
Installation Recommendations
Recommended For Experienced Mechanics Or Confident DIYers. Typical replacement steps:
- Disconnect The Negative Battery Terminal Before Starting Work To Prevent Short Circuits.
- Remove The Door Trim Panel: Carefully pry off trim clips with a plastic trim tool to avoid breaking retainers; remove any screws (commonly Phillips or Torx) securing the panel.
- Detach Linkages And Electrical Connectors: Unclip the lock/handle linkage rods and any switch connectors routed near the handle area.
- Remove The Old Handle: Unscrew or unclip the interior handle from its mounting; note fixation points and orientation for reassembly.
- Install The New Handle: Connect linkages, ensure clips and screws are seated, then test mechanical operation before reassembling the door card.
- Reassemble The Door Panel And Reconnect The Battery.
Tools Commonly Needed: Trim removal tool, Torx (T20/T25) or Phillips screwdrivers, small flat screwdriver, 10 mm socket or ratchet for retaining bolts. Replace any broken plastic clips or rivets to ensure secure fitment.
Why This Part Fails Most Often
- Plastic Fatigue And Broken Tabs: Repeated use and mechanical stress cause plastic levers or mounting tabs to crack or shear.
- Worn Internal Mechanism: Internal pivot points and springs can wear, leading to poor or intermittent operation of the latch release.
- Impact And Misuse: Excessive force, accidental door impacts, or prying at the handle accelerate damage.
- Cosmetic Wear: Surface finish degrades over time from UV exposure, solvents, or abrasion, prompting replacement for aesthetic reasons.
Notes For Buyers
This part is commonly searched and ordered by original part numbers listed above. Inspect the door trim clips and linkage condition during replacement; damaged clips should be renewed to avoid rattles and ensure proper alignment. If the latch or lock mechanism shows symptoms of binding or corrosion, address those components simultaneously to prevent repeated failures.
