Description
Electric Motor – VALEO Rear Wiper Motor
For Vehicles CITROËN C4 II B7, PEUGEOT 308 SW And Hatchback 2010, PEUGEOT 3008 And 5008 First Generation
Description
This rear wiper electric motor manufactured by VALEO is designed for Stellantis hatchbacks and estates and fits a range of CITROËN and PEUGEOT models. It replaces the original tailgate wiper drive and restores reliable park positioning and wiping function on the rear window. The unit is compatible with the listed part numbers and is a common spare when the rear wiper stops moving, parks incorrectly, or makes excessive noise.
Fitment
Compatible Models:
- CITROËN C4 II (B7)
- PEUGEOT 308 SW
- PEUGEOT 308 Hatchback (2010)
- PEUGEOT 3008 I (First Generation)
- PEUGEOT 5008 I (First Generation)
Technical Information
- Manufacturer: Valeo
- Model: Rear Wiper Motor
- Product Codes: 9680477480, 53031812, 6405JQ
- Additional Numbers: 9680477480 / 53031812 / 6405JQ
Function And Typical Symptoms
The rear wiper motor drives the wiper arm and linkage on the tailgate. Its main functions are to move the wiper blade across the glass, return the arm to the park position, and withstand outdoor exposure. Common symptoms of a failing motor include no movement, intermittent operation, slow or weak wiping, grinding or clicking noises, and incorrect park position.
Why This Part Fails Most Often
Typical failure causes include:
- Water ingress and corrosion at the gearbox or motor brushes due to damaged seals or prolonged exposure to moisture.
- Worn carbon brushes or commutator wear in the electric motor after many duty cycles.
- Mechanical wear or stripping of the gearbox and splines from age, ice loads, or excess resistance on the blade.
- Electrical connector corrosion or wiring faults leading to intermittent or no power.
Installation / Replacement Guide
Recommended For: Experienced DIYers and Professional Technicians.
- Preparation: Park the vehicle with the wiper in the parked position. It is good practice to disconnect the negative battery terminal before working on electrical components to avoid short circuits.
- Remove Interior Trim: Open the tailgate and remove the interior trim panel to access the motor and linkage. Keep fasteners organized.
- Remove Wiper Arm: Mark the wiper arm position on the glass, then remove the retaining nut and lift off the arm.
- Disconnect Electrical Connector: Unplug the motor connector and any retaining clips.
- Unbolt Motor: Remove the mounting bolts securing the motor to the tailgate and detach the linkage from the motor shaft.
- Install New Motor: Fit the replacement motor, attach the linkage, and loosely install mounting bolts. Ensure the motor is in the correct park position before final tightening.
- Torque And Test: Tighten fasteners to manufacturer torque values, reconnect the electrical connector and battery, then test the wiper function and park position. Adjust the arm position if necessary and refit the tailgate trim.
Recommendations
- Inspect wiring and connector for corrosion when replacing the motor; poor connections often cause intermittent faults.
- Lubricate linkage pivot points with an appropriate grease and ensure seals around the motor spindle are intact to reduce future water ingress.
- Replace the wiper arm or blade if worn to avoid excessive load on the motor.
- When aligning the new motor, ensure the park position is correct to prevent the arm from stopping mid-sweep.
Lifespan
Service life varies with usage and environment. Rear wiper motors commonly last many years but can fail earlier in harsh climates or with frequent use. Check the system if you notice noise, sluggish movement, or loss of park position.
Notes
Searches for this part are frequently performed by part number (9680477480, 53031812, 6405JQ). If your vehicle matches the listed models and symptoms, this VALEO rear wiper motor is a direct-fit replacement designed to restore reliable rear wiping performance.
