Description
MAGNETI MARELLI control unit Marelli Injection additives – FAP Filter particulate
For Citroen C-Crosser and Peugeot 4007
FAP (ECU) MAGNETI MAGNETI MAGNETI for Citroën C -Crosser and Peugeot 4007. The unit controls the dosing additive (EOLYS) into fuel to facilitate the regeneration of the particulate filter. Suitable as a replacement for the original part with the same codes 9663094180, 1860ab003, 1525.NP.
Unit function: When refueling, it determines the correct dose of additive to the fuel tank based on information from the vehicle network (CAN). The additive reduces the soot burning temperature, speeds up FAP regeneration and protects the filter from premature clogging. In practice, defective ECU additive is manifested by FAP error messages, non -functional additives, engine light or emergency mode.
Installation and commissioning: The unit is usually located in the rear of the car near the additive tank. When replacing, we recommend disconnecting the battery, check the condition of the connector and cabling (the humidity/corrosion damage) and after installation to make telekoding and basic settings via diagnostics (Diabox/Lexia/PP2000). It is necessary to choose the correct type of additive and initialize the filling of the additive tank and the FAP system.
Compatibility: Designed for diesel versions with FAP. You can get the highest certainty of compatibility by comparing the part number from the label of the original unit with the codes. In the case of confusion of code, configuration (telecoding) may be required according to the equipment of the car.
technical information
- Manufacturer: Magneti Marelli
- Model: Citroën C -Crosser (2.2 HDI FAP), Peugeot 4007 (2.2 HDI FAP)
- product codes: dog 1525.NP; Dog/Continental ref. 9663094180; Mitsubishi 1860ab003
- Other numbers: Not specified
Practice Tip: This unit suffers from water and salt due to the chassis. When mounting, we recommend treating the connector contacts and check the tightness of the covers. After replacement, always perform a complete additive test (pump activation, flow control and reset of counters in the control system).
