Description
DVD and Multimedia player bundle for Citroen C4 Picasso cars of the first generation
Part description
This pre-owned DVD and Multimedia Bundle is for a first generation Citroën C4 Picasso. It is an electrical component intended for the connection of multimedia elements, where the compatibility of connectors, cabling and product codes is especially important. Parts of this type are often searched for by the original designation, so it is good to pay attention to all the numbers listed.
The wiring harness is suitable as a replacement for a damaged, broken or non-functional original part. The advantage of used car parts is the availability of original designs for Citroën and Peugeot cars within the Stellantis concern, which will be appreciated by both car repair shops and home mechanics when repairing multimedia equipment.
Technical information
- Manufacturer: Stellantis Citroën Peugeot
- Model: Citroën C4 Picasso first generation
- Other numbers: 9656743980, 6574C3, NFP
Product codes
- Product codes: 9656743980, 6574C3
- Models from labels/backgrounds: Citroën C4 Picasso
Installation recommendations
Generally/typically, the exact replacement procedure for the multimedia system bundle depends on the specific design of the car and the extent of the wiring connection. Below is a safe general procedure for replacing an electrical part of this type.
1) Before assembly
- Check that the part codes and connector designs match the old harness.
- Compare the length of the wiring, the number of branches, the type of termination and any fasteners.
- Inspect the used part for damaged insulation, broken connector latches, or signs of improper repair.
- Disconnect the battery before working to avoid a short circuit or damage to the electronics.
2) Necessary tools and materials
- Basic set of hand tools
- Plastic levers for panel removal
- Cleaning agent for electrical contacts
- Torch or work light
- Protective gloves
3) Step-by-step assembly procedure
- Disconnect the battery and wait for the car’s electronic systems to go to rest.
- Access the space where the original volume is kept and mounted.
- Carefully remove covers or trims if they obstruct access to wiring.
- Document the management of the original bundle, for example with photos before disassembly.
- Unplug individual connectors without using excessive force and check their condition.
- Release the harness from the brackets, clamps, and conduit so as not to damage the surrounding wiring.
- Compare the old and new part side by side and verify that all important points match.
- Place the replacement bundle in the same route as the original piece was routed.
- Secure the wiring in the original mounts so that it does not rub and is not pulled.
- Connect all the connectors carefully and check that they click properly.
- Reinstall all removed covers and trim.
- Connect the battery and perform a basic function check of the multimedia system.
-
4) Post-assembly checks and function verification
- Make sure the connectors are tight and the wiring is not pinched anywhere.
- Check the function of the connected multimedia device or system.
- Monitor for power outages, signal interruptions, or erratic device behavior.
- After a short test check, recheck the bundle guide and its attachment.
5) The most common assembly mistakes + how to avoid them
- Swapping connectors – mark or take a picture of everything before disconnecting.
- Damage to latches – never pry connectors with brute force.
- Poor wiring – route the harness the same as the original part to avoid chafing.
- Connecting with the battery connected – always disconnect the car’s power supply first.
- Overview of damage to the used part – carefully check the insulation and connectors before assembly.
Reasons why the part is damaged
- Mechanical damage during careless disassembly or assembly of multimedia components
- Breaking or interruption of wires due to long-term stress
- Insulation damage by rubbing against surrounding parts
- Defective or loose connectors
- Oxidation of contacts and moisture in electrical installation
- Unprofessional interventions in the original cabling
