Passenger Airbag Deactivation Switch Citroën Peugeot 96413912ZD 6556E6

Description

Passenger Airbag Switch For CITROËN, PEUGEOT, DS Vehicles

The Passenger Airbag Switch is a direct-fit safety control used to enable or disable the front passenger airbag on a range of Citroën, Peugeot and DS models. This switch is essential when transporting a rear-facing child seat or in cases where the passenger airbag must be deactivated for safety reasons. Commonly searched by its part numbers, the unit supplied corresponds to multiple OEM references and is suitable for professional workshops and DIY mechanics who require a reliable replacement part.

Technical Information

• Manufacturer: Stellantis (Citroën / Peugeot / DS)
• Model: Passenger Airbag Switch
• Product Codes: 96413912ZD, 96413912XT, 9641391277
• Other Numbers: 96373205ZD, 6556E6
• Compatible Vehicles: Citroën C3 Aircross; Citroën C3 III; Citroën C3 Picasso; Citroën C4 Picasso; Citroën C8; Peugeot 207; Peugeot 3008 I; Peugeot 308; Peugeot 308 (T9); Peugeot 5008 I; Peugeot 807

Features And Function

The switch provides a manual means to deactivate the passenger-side frontal airbag. It typically operates via a key or rotary mechanism and communicates the airbag state to the vehicle’s SRS (Supplemental Restraint System). When set to “off,” the system prevents deployment of the passenger airbag, which is required when certain child seats occupy the front passenger seat. The switch must reliably send correct status information to avoid false SRS warnings or incorrect airbag behavior.

Replacement Procedure

1. Park the vehicle on a level surface and place the ignition in the Off position.
2. Disconnect the negative battery terminal and wait at least 10 minutes to allow SRS capacitors to discharge.
3. Remove the trim panel covering the switch (location varies by model — check around glovebox, passenger-side dash, or side of dash panel).
4. Release the retaining clips or remove the fixing screws that secure the switch.
5. Disconnect the electrical connector from the old switch and remove the unit.
6. Fit the replacement switch, reconnect the electrical connector and secure the unit in place.
7. Refit the trim panel, reconnect the battery, and perform a system check: switch positions should be recognized and the SRS indicator should behave normally on ignition.

Installation Recommendations

• Always Disconnect The Battery Before Working On SRS Components.
• Observe ESD Precautions And Handle Connectors Carefully To Avoid Bent Pins.
• Use Correct Trim Removal Tools To Prevent Damage To Panels.
• After Installation, Verify Switch Function By Checking Instrument Cluster SRS Messages And By Confirming The Switch Changes State Correctly.
• If The SRS Warning Light Persists After Replacement, Diagnose Using Appropriate Diagnostic Equipment; Fault Codes May Indicate Wiring Or SRS Module Issues.
• Do Not Attempt To Repair Airbag Modules Or Wiring Yourself; Follow Manufacturer Procedures.

Most Common Failure Reasons

• Mechanical Wear Of The Rotary Or Key Mechanism Causing Poor Contact Or Sticking.
• Corrosion Or Contamination On Electrical Contacts Leading To Intermittent Or No Signal To The SRS System.
• Damage From Impact Or Excessive Force During Operation Or Removal.
• Internal Plastic Breakage From Age Or Repeated Use.
• Faults In Associated Wiring Or Connectors That Present As Switch Failure.

This Passenger Airbag Switch Is Intended For Professional Installation Or For Owners Comfortable With SRS Precautions. Use The OEM Part Numbers Above To Confirm Fitment For The Specific Vehicle Model And Year.