Description
Rear left wing lamp (driver side) for PEUGEOT 307 CC. The lamp has been resealed with silicone, does not mist up and the acrylic cover will not detach. WARNING: The lamp has lightened/faded over time; the second photo shows a new part.
Product Overview
This rear left tail lamp is a direct-fit replacement for the Peugeot 307 CC and is intended for mechanics and DIY enthusiasts who demand a reliable body-lighting solution. The unit has been professionally resealed with silicone to prevent fogging and to keep the acrylic lens firmly attached to the housing. Due to age or UV exposure, the original lens may appear lightened in the photos; the second image displays a brand-new unit.
Key Benefits
- Resealed With Silicone To Prevent Moisture Ingress And Fogging
- Secure Acrylic Lens Attachment Reduces Risk Of Detachment
- Direct Replacement For Driver-Side Rear Wing
- Suitable For Use By Professional Workshops And Experienced DIYers
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Peugeot 307 CC (Coupe Cabriolet); Fits 307 I And II Variants
- Product Codes: 714025600761
- Other Numbers: 6350S3, 6350X4
Installation Recommendations
Fitting this tail lamp is straightforward for a trained technician or competent DIYer with basic tools. Typical installation steps:
- Open Boot And Remove Interior Trim Panels To Access Lamp Retaining Nuts.
- Unscrew Fasteners, Carefully Release Clips And Pull The Lamp Assembly Outwards.
- Disconnect Electrical Connector And Remove Old Unit.
- Check And Replace Bulbs Or Sockets If Necessary Before Installing The New Lamp.
- Clean The Mating Surface On The Bodywork, Fit The New Lamp, Reconnect Wiring And Secure Fasteners Without Over-Tightening.
- Verify All Light Functions (Brake, Tail, Indicator, Reverse If Applicable) And Check For Any Signs Of Moisture After Installation.
Use New Clips Or Grommets If The Old Ones Are Damaged, And Take Care Not To Over-Torque Mounting Nuts To Avoid Cracking The Housing.
Why This Part Commonly Fails
- UV Exposure And Weathering: Lens Material Can Fade, Yellow Or Lose Transparency Over Time, Causing The “Lightened” Appearance.
- Seal Degradation: Original Seals Can Deteriorate, Allowing Moisture Ingress And Condensation—This Unit Has Been Resealed To Address That.
- Impact Damage: Parking Bumps Or Minor Collisions Often Crack Or Break The Housing Or Lens.
- Connector Corrosion Or Bulb/Socket Wear: Electrical Faults May Cause Intermittent Function Or Complete Failure.
- Thermal Cycling: Repeated Heating And Cooling Can Weaken Clips And Seals Over Years Of Use.
Notes
Check The Photos Carefully: The Listing Notes That The Supplied Lamp Has Lightened Over Time, While The Second Photo Shows A New Replacement Unit. Ensure You Match The Product Codes Listed In The Technical Information With The Part Required For Your Vehicle.
