Description
Rear left wing taillight, driver’s side, for Peugeot 307 CC. The lamp has been resealed with silicone, does not mist up, and there is no risk of the plexiglass detaching.
This rear left taillight is a direct-fit replacement for the Peugeot 307 CC and is frequently searched by its product codes. The unit restores correct rear lighting function, reflector visibility and the original appearance of the vehicle’s rear corner. The resealed construction prevents water ingress and reduces the risk of condensation, ensuring reliable operation in wet conditions.
Features
- Direct replacement for rear left (driver side) wing taillight on Peugeot 307 CC.
- Resealed with silicone to prevent fogging and water ingress.
- Maintains original mounting points and connector layout for straightforward fitment.
- Includes brake, tail and indicator lamp compartments as per original specification.
Compatibility
Fits: Peugeot 307 CC (convertible) – rear left / driver side. Often identified by part numbers and reference codes listed below. Verify vehicle model and lamp position when ordering.
How To Replace
Replacement is generally uncomplicated and suitable for experienced DIYers and professional technicians. Typical replacement steps:
- Park vehicle on level ground, switch off ignition and remove key.
- Access taillight from inside the trunk/boot by removing the trim panel covering the lamp area.
- Disconnect the electrical connector and remove the fixing screws or nuts securing the lamp to the wing.
- Remove the old lamp, fit the replacement into the mounting aperture, secure fasteners and reconnect the electrical plug.
- Check all light functions (tail, brake, indicator, reverse if applicable) before reassembling interior trim.
- Observe manufacturer torque values for fasteners and ensure seals are properly seated to avoid leaks.
Recommendation For Installation
Always handle the lamp by the housing and avoid touching bulbs and contacts with bare hands. Ensure mating surfaces are clean and dry before installation. If the unit is resealed, check the silicone joint for continuous coverage. After installation, perform a full functional test of all lamp circuits. If any wiring or connector damage is present, repair before fitting the new lamp.
Why This Part Commonly Fails
Typical failure causes for taillights include moisture ingress due to cracked seals or damaged lens, impact damage from minor collisions, UV-induced lens clouding or yellowing, and corrosion of bulb holders or connectors. Poor factory or previous repairs can also allow water to enter, causing fogging or electrical faults. Resealing with silicone addresses the most common cause—water ingress—thereby improving longevity.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 307 CC (Rear Left / Driver Side)
- Product Codes: 714025600761, 6350S3, 6350X4
- Additional Numbers: Reference codes as listed above
Notes
This item is commonly searched by the catalog numbers listed in the Technical Information section. Make sure you select the rear left (driver side) position when ordering. For a durable result, follow the installation recommendations and inspect surrounding wiring and seals during fitment.
