Description
Window regulator mechanism for the right front window for Peugeot 307 CC — Passenger Side.
This electric window regulator is designed for the passenger-side front window of the Peugeot 307 CC. Built to restore smooth, reliable window operation, it replaces worn or failed mechanisms that cause slow, noisy, or non-functioning window travel. Ideal for professional mechanics and DIY enthusiasts, the unit is often searched for by its product codes and fits a number of 307 body variants.
Technical Information
- Manufacturer: Stellantis / Citroën Peugeot
- Model: Peugeot 307 CC (compatible with some Peugeot 307 variants)
- Product Codes: 9656221480, 9222V9, 1619991980, NFP
- Additional Numbers: 9222V9 (also referenced in product title)
Key Features And Benefits
- Restores proper electric window operation on the right front (passenger) side.
- Designed to meet OE fitment standards for a direct replacement installation.
- Improves safety and convenience by eliminating stuck or unreliable windows.
- Commonly found and ordered using the listed product codes for quick identification.
Installation Recommendations
Installation should be performed by a qualified technician or an experienced DIYer with basic tools. Recommended steps:
- Disconnect the negative battery terminal before starting to avoid short circuits.
- Remove inner door trim and moisture barrier carefully to access the regulator assembly.
- Support the window glass (tape or prop) before detaching the regulator to prevent glass drop or breakage.
- Disconnect electrical connector and unbolt the regulator/motor assembly from the door shell.
- Transfer any required mounting clips or glass brackets to the new regulator, fit the new unit, and tighten fasteners to manufacturer torque specs where available.
- Reconnect the electrical connector, temporarily reconnect the battery, and test the window travel through full cycle to ensure smooth operation and correct alignment before reassembling the door trim.
- Use appropriate lubricant on guide channels and check for water ingress points to prolong service life.
Why This Part Fails (Most Common Causes)
- Motor Wear: Repeated use and age lead to motor weakening or electrical faults causing intermittent or complete failure.
- Cable Or Slider Wear: Fraying cables, stretched components or worn sliders can cause binding or loss of movement.
- Plastic Gear Or Bearing Failure: Internal plastic components can fatigue or break, especially when exposed to dirt or moisture.
- Corrosion And Water Ingress: Moisture entering the door can corrode linkages or electrical contacts, accelerating failure.
- Obstructions And Overload: Frozen seals, debris in the window channel or repeated forced operation can overload the mechanism.
Practical Tips
- When replacing the regulator, inspect door wiring, connectors and the window glass run channels for damage—repairing these can prevent repeat failures.
- Test full travel and auto functions (if present) before final reassembly to avoid repeat disassembly.
- Keep door drainage holes clear to reduce the risk of corrosion and extend the life of the regulator.
This replacement window regulator is a practical solution for restoring reliable front passenger-side window operation on Peugeot 307 CC vehicles. Use the product codes above to confirm correct part selection for your application.
