Description
Complete wiring harness for the front driver’s seat for Peugeot 3008 and 5008 first generation.
Product Overview
This complete front driver seat wiring harness is designed for Peugeot 3008 I and Peugeot 5008 I models. It routes power and signal connections for seat adjustment motors, heating elements, occupant detection sensor and side airbag circuits where applicable. The harness is a direct-fit component intended for professional fitment by automechanics or experienced DIY technicians performing seat repairs or replacements. Commonly referenced under the code 6545XR, this part ensures reliable electrical connectivity between the seat and vehicle wiring loom when installed correctly.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 3008 I; Peugeot 5008 I (First Generation)
- Product Codes: 6545XR
- Additional Numbers: Not Available
Fitment And Replacement
Fits First Generation Peugeot 3008 and 5008. Typical replacement scenarios include damaged connectors, torn insulation, or electrical faults affecting seat adjustment, heating or airbag/occupancy circuits. Replacement steps (summary):
- Disconnect The Battery And Wait At Least Two Minutes Before Starting Work To Prevent Airbag Deployment.
- Remove Seat Trim And Fixings To Access Connector Plugs And Mounting Points.
- Label Or Photograph Connector Positions Before Unplugging To Ensure Correct Reassembly.
- Unbolt Seat From Floor If Required To Give Access To Harness Routing.
- Disconnect All Electrical Connectors, Carefully Release Any Retaining Clips And Remove The Old Harness.
- Install The New Harness Following The Original Routing, Secure With Clips And Fasteners, And Reconnect All Plugs Firmly.
- Reinstall Seat, Torque Bolts To Manufacturer Specification, Reconnect Battery And Verify Functionality Of Adjusters, Heaters And Airbag/Occupancy Sensors.
Installation Recommendations
Work With The Proper Tools: trim tools, torque wrench and an OBD-II scanner are recommended. Inspect Connectors And Pins For Corrosion Or Damage; Replace Any Damaged Terminals. Use Dielectric Grease Sparingly On Exposed Pins To Prevent Corrosion Where Appropriate. Ensure All Airbag-Related Connectors Are Reconnected Correctly—Faults In These Circuits Will Trigger Airbag Warning Lights And May Require Fault Clearing With Diagnostic Equipment. Secure The Harness To Prevent Chafing Against Seat Rails Or Sharp Edges.
Most Common Failure Causes
Wiring Harness Failures Typically Result From Mechanical Wear And Fatigue Due To Seat Movement, Chafing Against Seat Rails, Corrosion Of Connectors From Moisture Ingress, Rodent Damage Or Accidental Cuts During Seat Removal. Faults Often Appear As Intermittent Electrical Issues, Seat Adjustment Malfunctions, Heater Failure Or Airbag/Occupant Sensor Fault Codes.
Why Choose This Part
Directly Targets The Electrical Circuits Of The Front Driver Seat On Peugeot 3008 I And 5008 I, Making It An Efficient Solution When The Original Harness Is Damaged Or Unserviceable. Ideal For Garages And Skilled DIYers Who Need A Reliable Replacement To Restore Full Seat Functionality.
Final Notes
After Installation, Perform A Full Functional Check Of Seat Adjusters, Heating Elements And Airbag/Occupancy Indicators. If Airbag Or Occupancy Faults Persist, Use Diagnostic Equipment To Read And Clear Trouble Codes Following Manufacturer Procedures.
