Description
Electric central locking actuator for the left front door for PEUGEOT 206. With oval connector. For 3-door and 5-door versions.
Product Overview
This replacement left front door lock/central locking actuator is designed for Peugeot 206 vehicles and features the characteristic oval electrical connector. It restores reliable central locking operation, eliminating intermittent locking, stuck latches or non-responsive door lock motors. Suitable for both 3-door (coupe) and 5-door (hatchback) variants of the Peugeot 206, the unit is a direct-fit part that mounts into the door lock mechanism and connects to the existing door linkages and wiring harness.
Key Benefits
- Direct Replacement: Fits Peugeot 206 left front door (3-door and 5-door).
- Reliable Operation: Restores central locking function and smooth mechanical movement.
- Easy To Install: Connector and mounting match OEM locations for straightforward swap.
- OEM-Style Connector: Oval connector for correct electrical compatibility.
Technical Information
- Manufacturer: Stellantis (Peugeot/Citroën)
- Model: Peugeot 206
- Product Codes: 9135H3
- Additional Numbers: NFP (as marked)
- Location: Left Front Door (Driver Side)
- Connector Type: Oval Electrical Connector
- Application: Central Locking Actuator / Door Lock
Compatibility
Designed for Peugeot 206 models equipped with central locking in the left front door. Compatible with both 3-door and 5-door body styles. Always verify part number 9135H3 against your existing unit to ensure fitment.
Installation Recommendations
- Preparation: Park vehicle on a level surface and ensure ignition is off. For electrical work, disconnect the negative battery terminal to avoid short circuits and protect vehicle electronics.
- Tools Required: Phillips and flat screwdrivers, trim removal tools, Torx or socket set (depending on door trim fasteners), pliers.
- Removal Steps: Remove inner door trim and protective moisture barrier. Disconnect the oval electrical connector from the actuator. Detach linkage rods and any retaining clips. Remove mounting screws or bolts and extract the old lock actuator.
- Installation Steps: Position the new actuator in the lock assembly, secure mounting screws/bolts, reconnect linkage rods and clips, attach the oval electrical connector, and refit the moisture barrier and door trim. Reconnect the battery and test central locking operation (lock/unlock using key, remote, and interior switch) before final reassembly.
- Time Estimate: Typical replacement time 30–60 minutes for an experienced technician; allow more time for first-time DIY installers.
Why This Part Fails Most Often
- Wear And Tear: Internal gears and the small electric motor wear over time, especially with frequent use.
- Water Ingress And Corrosion: Moisture penetrating the door (failed moisture barrier or worn seals) can corrode contacts and mechanical parts.
- Mechanical Stress: Bent or broken linkage rods, damaged latch mechanism or impact to the door can overload the actuator.
- Electrical Issues: Corroded connectors, damaged wiring or intermittent power supply reduce actuator life.
- Freezing And Contamination: Dirt, rust or ice in the latch assembly can prevent movement and overload the actuator motor.
Additional Advice
When replacing the actuator, inspect door linkages, latch mechanism, and the moisture barrier. Repair any worn seals or damaged linkages to prevent premature failure of the new unit. After installation, confirm smooth mechanical operation before refitting the trim to avoid rework.
