Description
Left Front Side Seat Airbag Peugeot 407 With Connecting Cable Driver’s Seat Color HZD – Black Mistral
This left front side seat airbag is a direct-fit safety module intended for the Driver’s Seat of Peugeot 407 vehicles. Supplied with the connecting cable, it replaces the seat-mounted side airbag unit that protects the pelvis and thorax in side-impact collisions. The part is often searched by its product code, making it quick to find for professional workshops and DIY mechanics looking for an exact match.
The module is a safety-critical component of the Supplemental Restraint System (SRS). It must be handled with caution, stored and fitted following standard SRS procedures, and verified with a diagnostic scan after installation to confirm system readiness. Typical uses include replacement after deployment in a crash or replacement due to electrical fault codes, damaged connectors, or visible physical damage to the seat side.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Peugeot 407 (Left Front Side Seat Airbag, Driver’s Seat)
- Product Codes: 96625550ZD, 8216QK NFP
- Additional Numbers: Color Code HZD – Black Mistral
Installation Recommendations
- Disconnect the vehicle battery and wait at least 10 minutes before starting work to reduce the risk of accidental deployment; follow the vehicle manufacturer’s recommended waiting time where available.
- Remove the seat upholstery trim carefully to avoid damaging clips and cable routing. Unbolt the seat if required to access the airbag module.
- Handle the airbag module with the airbag surface facing away from your body. Do not expose the connector pins to contaminants; ensure the mating connector and cable are undamaged and correctly engaged.
- Tighten seat fasteners and airbag mounting bolts to the vehicle manufacturer’s specified torque values. Do not overtighten.
- After installation, reconnect the battery and perform an SRS system check with an appropriate diagnostic tool to clear stored faults and confirm proper communication with the airbag control unit.
- If any SRS fault persists after fitting, diagnose the wiring harness, connectors, and control unit before returning the vehicle to service.
Most Common Failure Reasons
- Deployment in a Collision: Airbags are designed to deploy in significant impacts and must be replaced after activation.
- Connector Or Wiring Damage: Corroded or damaged connectors and harnesses under the seat can interrupt circuit continuity and trigger fault codes.
- Water Or Moisture Ingress: Spills or water penetration into the seat area can cause electrical faults or corrosion.
- Physical Damage During Seat Removal Or Repair: Incorrect handling when removing trims or seats can damage the airbag module or cable.
- Internal Faults Detected By SRS: Aging, manufacturing defects, or impact-related internal damage can lead to stored error codes and require replacement.
Note: Airbag modules do not have a prescribed service interval and are normally replaced only after deployment or when diagnostics indicate a fault. Use the listed product codes to confirm fitment when searching or ordering to ensure correct compatibility with the Peugeot 407 seat configuration.
