Description
Bosch Accelerator Pedal for Citroën Berlingo and Peugeot Partner.
This Bosch electronic accelerator pedal assembly is a direct-fit replacement for various Citroën Berlingo and Peugeot Partner models. Designed for professional workshops and competent DIY mechanics, the unit restores precise throttle response and reliable pedal position feedback to the engine control system. The part is commonly referenced by OE numbers and aftermarket codes, so customers often search by the product code to ensure correct fitment.
Key Benefits
Reliable Bosch quality: durable construction and accurate position sensing. Improved Driving Feel: Restores smooth throttle input and helps eliminate hesitation or erratic idle caused by a degraded pedal sensor. Workshop-Friendly: Direct replacement design with the same mounting points and electrical connector as the original.
Compatibility And Fitment
Intended For: Citroën Berlingo, Peugeot Partner. Check the product codes below against the vehicle’s existing part number to confirm mechanical and electrical match. This pedal is typically used on Stellantis group small vans with electronic throttle control.
Technical Information
- Manufacturer: Bosch
- Model: Citroën Berlingo; Peugeot Partner
- Product Codes: 9655467180; 0280755035; 1601T8
- Other Numbers: Stellantis Citroën Peugeot references
Function And Common Symptoms Of Failure
The accelerator pedal assembly houses the position sensor(s) that communicate pedal angle to the engine management system (drive-by-wire). When the sensor or its wiring fails, symptoms can include delayed or unresponsive throttle, inconsistent engine idle, reduced engine power or limp-home mode activated by the ECU. Faults may also trigger warning lights or diagnostic trouble codes reported by the vehicle’s control modules.
Typical Failure Causes
- Sensor Wear Or Drift: Over time the internal sensing element can degrade, causing incorrect position signals.
- Connector Or Wiring Damage: Corrosion, broken wires, or pin damage at the connector causes intermittent or permanent signal loss.
- Moisture Ingress And Contamination: Water or dirt entering the assembly can impair the sensor electronics.
- Mechanical Wear: Pedal bearings, bushings or return springs can wear, affecting pedal travel and sensor readings.
Installation Recommendations
- Disconnect Battery: Always disconnect the vehicle battery before starting work to avoid electrical damage or unwanted ECU events.
- Follow Manufacturer Procedure: Remove trim panels and fasteners to access the pedal assembly. Disconnect the electrical connector and remove mounting bolts. Install the new pedal in reverse order.
- Check Wiring And Connector: Inspect the harness and connector for corrosion or damage and repair if necessary before fitting the new pedal.
- Tighten To Spec: Fasten mounting bolts to the manufacturer’s torque specification where provided. If torque data is not available, ensure secure and even fastening without over-torquing.
- Post-Installation Checks: Reconnect the battery, verify pedal movement is smooth and unobstructed, start the engine and confirm normal throttle response. Clear any stored fault codes using diagnostic equipment if required.
Maintenance And Service Tips
Keep the pedal area clean and free of spilled liquids and dirt. Periodically inspect the connector for moisture ingress and secure routing of the wiring harness to avoid chafing. If intermittent throttle issues occur, check for loose connectors or damaged wiring before replacing the pedal.
Buy with confidence knowing this Bosch accelerator pedal is a widely used OE-level replacement for Citroën Berlingo and Peugeot Partner models. Use the product codes listed above when searching to quickly find the correct unit for your vehicle.
