Description
Driver airbag for the steering wheel for Citroën C4 first generation. Finish HZD – Black Mistral. With one squib.
Product Overview
This driver airbag assembly is designed for the steering wheel of the Citroën C4 (first generation) and is commonly referenced by part numbers 96823829ZD and 4112KF. Built to the original style and aesthetic (Black Mistral finish, HZD designation), the module includes a single squib (inflator initiator). The unit is intended for professional repair shops and experienced DIY mechanics who perform airbag and steering wheel service.
Key Features
- Direct-fit steering wheel driver airbag for Citroën C4 I.
- Finish: Black Mistral (HZD) for visual match with OEM interiors.
- Single squib inflator suitable for the original vehicle airbag circuit.
- Often searched and identified by product codes 96823829ZD and 4112KF — include these numbers when sourcing or cross-referencing.
Technical Information
- Manufacturer: Stellantis / Citroën
- Model: Citroën C4 I (First Generation)
- Product Codes: 96823829ZD, 4112KF
- Additional Numbers: Group: Stellantis (Citroën/Peugeot)
Installation Recommendations
- Safety First: Disconnect the negative battery terminal and wait at least 10–15 minutes to allow SRS capacitors to discharge before starting work.
- Tools: Torx set (common sizes for airbag retaining screws), ratchet, appropriate screwdrivers, and a torque wrench for steering wheel fasteners.
- Removal: With battery disconnected, remove the airbag retaining screws from the back of the steering wheel, carefully pull the airbag module forward and disconnect the airbag connector(s) (observe connector locking tabs).
- Steering Wheel Alignment: Mark steering wheel position relative to the shaft before removal to maintain proper alignment when reinstalling.
- Installation: Connect the airbag connector(s) securely, position the module, tighten retaining screws to the manufacturer’s torque specification, and only then reconnect the battery.
- Post-Installation: After reconnection, verify that the SRS warning lamp behaves correctly (lamp on at key-on self-check, then off). If the SRS lamp remains lit, check connectors and related components (clock spring/spiral cable) and clear codes using proper diagnostic equipment.
- Recommendation: Perform installation in a clean, dry environment and avoid touching connector pins or squib terminals directly.
Why This Part Most Frequently Fails
- Deployment in a Collision: Airbags are single-use safety devices — once deployed they must be replaced.
- Connector Or Wiring Damage: Corrosion, loose contacts or damage to the airbag wiring or clockspring/spiral cable can trigger faults or prevent proper operation.
- Previous Improper Repairs: Incorrect handling, improper removal or damaged retention hardware from prior interventions can lead to malfunction.
- Environmental Factors: Moisture ingress or contamination can compromise connectors and inflator circuitry.
- Age-Related Electrical Faults: Over long service life electrical degradation in connectors or squib circuits can cause SRS errors.
Notes For Mechanics And DIY Enthusiasts
When ordering or searching for this item, include the product codes (96823829ZD, 4112KF) and vehicle model (Citroën C4 I) to improve search accuracy. Replace airbag modules only with compatible units and follow manufacturer safety procedures. If the SRS warning lamp persists after replacement, inspect the clockspring (spiral cable) and SRS connectors and use a compatible diagnostic tool to read and clear fault codes.
