Description
Driver airbag for CITROËN BERLINGO from 2002. Color FXT – Black Cornelie.
Product Overview
Replacement driver (steering wheel) airbag for Citroën Berlingo. This airbag module restores frontal occupant restraint functionality after deployment or damage and is commonly searched by part number (e.g. 96454032XT). Designed for direct fit into the steering wheel hub, it is suitable for mechanics and experienced DIYers who follow safety procedures. Keywords: driver airbag, steering wheel airbag, Citroën Berlingo airbag, 96454032XT, airbag module.
How It Works
The driver airbag is an integral part of the Supplemental Restraint System (SRS). On severe frontal impact the airbag inflates within milliseconds to reduce the risk of head and chest injuries. The module contains the inflatable bag, inflator (pyrotechnic charge or gas generator) and an electrical connector that links to the vehicle SRS sensors and control unit.
How To Replace
Replacement requires care and adherence to safety rules. Basic steps (overview only):
- Disconnect the vehicle battery and wait at least 10 minutes to allow residual SRS energy to dissipate.
- Remove the steering wheel trim and fasteners (typically Torx or similar) holding the airbag module.
- Carefully disconnect the airbag electrical connector(s) and remove the module from the steering wheel hub.
- Install the new airbag, connect the connector(s) securely and reassemble the steering wheel. Do not rotate the clock spring beyond its neutral position.
- Reconnect the battery and verify SRS warning lamp behavior according to the vehicle service manual.
Always follow the vehicle manufacturer procedure and torque values. If you are not experienced with SRS work, have the replacement performed by a qualified technician.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën Berlingo II (from 2002)
- Product Codes: 96639595XT01, 96454032XT00, 96454032XT01, 96454032XT
- Additional Numbers: 4112GG, 98158975XT, 98032239MJ
- Color: FXT – Black Cornelie
Installation Recommendations
- Always Disconnect The Battery Before Starting Any Work On The SRS; Wait At Least 10 Minutes.
- Use Proper Tools And Follow Manufacturer Procedures To Avoid Damaging The Clock Spring Or Airbag Connectors.
- Do Not Apply Solvents Or Mechanical Force To The Airbag Module Or Inflator.
- After Fitment, Verify SRS Warning Lamp And Perform Any Required System Checks Using Proper Diagnostic Equipment.
- Retighten Steering Wheel Fasteners To The Manufacturer Specified Torque.
Why This Part Most Often Fails
Airbags usually become nonfunctional after deployment in a collision. Other common causes of failure include electrical connector corrosion or damage, water ingress into the steering wheel area, damage to the clock spring, prior improper repairs, and faults reported by the SRS control unit (e.g. sensor or wiring issues). The SRS warning lamp is the primary indicator of a fault affecting airbag readiness.
Notes For Mechanics And DIYers
Because airbag modules are safety-critical, correct handling and installation are essential. Keep part numbers (e.g. 96454032XT) handy when sourcing replacements, as many technicians search by these codes. When in doubt about electrical diagnostics or SRS lamp faults, use manufacturer-level diagnostic tools or consult a qualified technician.
