Description
Complete engine wiring harness for Citroën and Peugeot vehicles with 2.0 HDI engines. It is from Citroën C4 Picasso 2.0 HDI RHJ.
High-quality complete engine wiring harness designed for 2.0 HDI engines, often searched under OE numbers 9684608680 and 6569RY. This harness routes power and signal connections between the engine control unit, injectors, sensors (crankshaft, camshaft, temperature, pressure, MAF), alternator, starter and ancillary components. Suitable for professional workshops and experienced DIY mechanics who perform engine-level electrical repairs or replacements. The harness is supplied as a full assembly, reducing installation time compared with repairing individual wires and connectors.
Key Benefits
– Direct-fit solution for vehicles equipped with the RHJ 2.0 HDI engine configuration.
– Includes factory connector interfaces and mounting points for secure routing.
– Restores reliable communication between ECU and engine sensors to eliminate intermittent faults, misfires, and no-start conditions related to damaged cabling.
When To Replace
Replace the engine wiring harness if you observe persistent fault codes related to multiple sensors, intermittent engine management faults, visible damage to insulation or connectors, or after events such as engine bay fires, coolant/oil leaks that have affected wiring, or rodent damage. There is no fixed service interval; lifespan depends on operating conditions, exposure to heat, fluids and mechanical wear.
Installation Recommendations
– Always Disconnect The Battery Before Starting Work. Remove negative terminal to avoid short circuits and damage to electronics.
– Label And Photograph Connectors Prior To Disassembly To Ensure Correct Reconnection.
– Follow Factory Routing And Secure With Original Clips And Fasteners To Prevent Chafing And Heat Damage.
– Inspect Connectors And Pins; Clean Or Replace Corroded Terminals Before Final Assembly.
– After Installation, Clear Fault Codes And Perform A Functional Check: verify sensor readings, idle stability and perform a road test.
– For Complex ECU Interfaces Or If The Harness Connects Directly To Control Modules, Consider Professional Assistance With Appropriate Diagnostic Equipment.
Most Common Failure Causes
– Heat And Vibration: Repeated thermal cycles and engine vibration lead to insulation cracking and broken conductors.
– Fluid Contamination: Oil, coolant or fuel leaks degrade insulation and accelerate corrosion of connector pins.
– Mechanical Wear And Chafing: Improper routing or missing clips allow wires to rub on sharp edges.
– Rodent Damage: Chewing can sever wires or expose conductors.
– Connector Corrosion: Moisture ingress leads to poor contact and intermittent faults.
Technical Information
Manufacturer: Citroën / Peugeot (Stellantis)
Model: Citroën C4 Picasso 2.0 HDI (RHJ)
Product Codes: 9684608680, 6569RY
Additional Numbers: N/A
Practical Tips For Mechanics
– Use A Multimeter To Check Continuity And Identify Shorted Or Open Circuits Before Replacing The Entire Harness.
– When Replacing Only A Section, Ensure Proper Crimping And Sealing With Heat-Shrink Or Factory-Style Repair Terminals.
– Secure Any Repaired Areas With Heat-Resistant Loom And Convoluted Tubing To Restore OEM-Level Protection.
– Record Any Changes And Note The Part Numbers For Future Reference—many customers search by OE number (9684608680 / 6569RY).








