Right Front Door Lock Citroën C3 4-Pin 46983280 9136N7

48.00

Stellantis citroën peugeot
46983280 9136N7 NFP

2 in stock

SKU: 3709-G8_K6 Categories: , ,

Description

Electric central locking actuator for right front door Citroën C3 4-pin

This 4-pin electric central locking actuator for the right front door is a direct-fit replacement commonly searched by part numbers 46983280 and 9136N7. Designed for professional workshops and DIY mechanics, it restores reliable locking and unlocking, improves vehicle security and convenience, and fits the original mounting and electrical connector for fast installation.

Installation Recommendations

For a safe and effective replacement, follow these steps: disconnect the negative battery terminal before you start; remove the door trim and protective moisture barrier; locate and unplug the 4-pin electrical connector; unclip or disconnect the lock linkage rods; remove the retaining screws or bolts and extract the old actuator; install the new actuator in the reverse order, reconnect linkages and connector, then test central locking operation before reattaching the door panel. Use basic hand tools, trim clips tools and a multimeter to verify power at the connector if needed. Apply a small amount of dielectric grease to the connector contacts to reduce corrosion and ensure a secure electrical connection.

Most Common Failure Reasons

Actuators typically fail due to mechanical wear of internal gears or the motor after long-term use, water ingress and corrosion from a damaged moisture barrier, broken plastic components or linkage clips, and connector or wiring harness faults caused by chafing or pin corrosion. Impact damage from door collisions or forced entry attempts can also break the actuator or its mounting points.

Technical Information

  • Manufacturer: Citroën / Stellantis
  • Model: Citroën C3 (Right Front Door)
  • Product Codes: 46983280, 9136N7
  • Other Numbers: NFP
  • Connector: 4-Pin Electrical Plug
  • Electrical System: 12 V
  • Type: Electric Central Locking Actuator

Practical Tips and Diagnostics

If the new actuator does not operate, first check fuses and the central locking control signals. Use a multimeter to confirm 12 V supply at the connector while activating the lock command. Inspect the door moisture barrier and drainage to prevent future water damage. When replacing, also check the condition of the door lock rods, clips and the exterior handle mechanism to avoid repeat failures.

Part numbers 46983280 and 9136N7 are commonly used when searching for this component — include them in searches to quickly find compatible replacements and installation guides.

Additional information

Weight 0.8 kg