Description
Passenger Airbag For PEUGEOT 3008 And 5008 First Generation
This right-side passenger (side) airbag is designed for the first-generation PEUGEOT 3008 and 5008. It provides essential side-impact protection for the front passenger and is identified by OE references commonly used in parts searches. The unit is a direct-fit replacement for vehicles that use the original equipment part numbers listed below, making it a practical choice for workshop repairs and do-it-yourself restorations.
Features And Benefits
– Direct-fit replacement for first-generation PEUGEOT 3008 and 5008 models, streamlining installation and reducing vehicle downtime.
– Designed to restore the vehicle’s side impact protection following airbag deployment or damage.
– OE part code visibility increases findability in parts databases and search engines (SEO-friendly: Peugeot 3008 airbag, Peugeot 5008 airbag, right side airbag).
Technical Information
- Manufacturer: Stellantis / PEUGEOT
- Model: PEUGEOT 3008 I (2008–2016), PEUGEOT 5008 I (2009–2016)
- Product Codes: 9684602380, 8216XX
- Other Numbers: N/A
Installation Recommendations
Work Should Be Carried Out By A Qualified Technician Or An Experienced DIY Mechanic With Proper Safety Precautions.
- Always disconnect the vehicle battery before starting work and wait at least 10–15 minutes to allow the SRS system capacitors to discharge.
- Follow the vehicle manufacturer’s removal sequence: remove trim panels and seat coverings as required to access the side airbag module.
- Carefully release electrical connectors using the locking tabs; avoid pulling on wiring. Inspect connector pins and harness for corrosion or damage.
- Unbolt the airbag module and install the replacement unit in the original orientation. Use manufacturer-specified fasteners and torque values where provided.
- After fitting, reconnect the battery and use an SRS-capable diagnostic tool to clear fault codes and verify system status. Ensure all airbag-related fault indicators are extinguished and perform any required system checks.
Most Common Failure Reasons
- Deployment After A Collision: The most frequent cause of a non-functional airbag is deployment during an accident; the unit must then be replaced.
- Electrical Or Connector Damage: Corrosion, pin damage, or poor connections in the airbag wiring harness can cause SRS faults and loss of function.
- Water Ingress Or Interior Damage: Moisture entering the door or cabin areas can damage connectors or the module itself.
- Physical Damage During Maintenance: Mishandling during seat removal or interior repairs can damage the airbag housing or wiring.
- Sensor Or Control Unit Faults: Faults elsewhere in the SRS system (sensors, wiring, or control unit) may indicate the airbag as defective even if the module is intact.
Practical Tips
– Verify That The OE Part Number Matches Your Vehicle (9684602380 / 8216XX) Before Ordering To Ensure Fitment.
– Replace Any Fasteners Or Clips Damaged During Removal. Use Correct Torque Values When Reinstalling Bolts.
– If The Airbag Was Deployed, Inspect Seatbelt Pretensioners And Other SRS Components As They May Require Replacement As Well.
Restore Side Impact Protection Quickly And Reliably — Ideal For Garages And Skilled DIYers Who Need A Correct-Fit Replacement For PEUGEOT 3008 I And 5008 I Models.
