Description
Center Seat Belt CITROËN XSARA PICASSO
Middle Position Behind Driver And Front Passenger
Color FXX – Black
This Center Rear Seat Belt for the Citroën Xsara Picasso is a direct-fit safety component designed for the middle-seat occupant behind the driver and front passenger. Supplied with part references 96314478XX and 8973N5, the belt comes in black (FXX) and is suitable for workshop replacement or DIY repair. Ideal for mechanics and owners who service their own vehicles, this belt restores occupant restraint performance and visual consistency of the interior.
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Citroën Xsara Picasso
- Product Codes: 96314478XX, 8973N5
- Additional Numbers: Stellantis CITROEN PEUGEOT
- Color: FXX – Black
- Position: Center Rear (Middle Seat, behind Driver and Front Passenger)
Function And Key Features
The seat belt provides primary passive safety for the middle-rear occupant by restraining body movement during sudden deceleration or collision. Typical components include the webbing, retractor mechanism (inertia reel), buckle/receiver and anchor points. The inertia retractor locks under rapid vehicle deceleration to secure the passenger. Materials and assembly are designed to meet the crash-load requirements specified by the manufacturer.
Replacement Procedure (Overview)
- Park the vehicle on a level surface and work with the ignition off.
- Remove the necessary interior trim panels to access the upper anchor, retractor and lower anchor bolts. Keep clips and fasteners to reuse where possible.
- Unbolt the old belt assembly from its anchors and disconnect any electrical connectors if the assembly includes sensors or pretensioners.
- Fit the new belt, route the webbing exactly as original, and hand-thread bolts before final tightening.
- Tighten all fasteners to the manufacturer’s specified torque values (refer to the workshop manual). Do not overtighten.
- Verify correct operation: webbing runs freely, retractor locks under sharp pull, and buckle latches securely.
Installation Recommendations
Follow Manufacturer Safety Procedures When Servicing Seat Belts. If The Assembly Includes A Pretensioner Or Any SRS Components, Observe SRS Safety Protocols And Manufacturer Instructions. Use Proper Tools And Torque Settings From The Workshop Manual. Check Anchor Points For Corrosion Or Damage And Replace Any Compromised Fasteners. After Installation, Perform A Functional Check And Inspect Routing To Ensure The Webbing Is Not Twisted Or Pinched.
Most Common Causes Of Failure
Seat belts most often fail or are replaced due to wear and tear (frayed or weakened webbing), contamination with dirt or liquids that impede retraction, jammed or sticky retractors, faulty buckles that no longer latch, corrosion of anchor bolts, or damage sustained in a traffic accident. Following a collision, even if the belt shows no obvious damage, replacement is often recommended because internal components (or pretensioners) may have been stressed.
Why Replace This Part
Replacing a damaged or malfunctioning center rear seat belt restores occupant safety and ensures compliance with legal requirements. A properly functioning belt reduces injury risk in a crash and maintains the intended protection for rear passengers.
Notes
Part Numbers 96314478XX and 8973N5 Are Frequently Used In Searches; Enter These Codes When Looking For Compatible Replacements Or Cross-References. Fitment Should Be Confirmed Against The Vehicle’s Model And Body Configuration Prior To Installation.
