Description
Left rear light for Peugeot 307 SW from 2005. Without bulb sockets, which can be purchased separately. Driver’s side.
Product Overview
High-quality left rear tail light assembly designed for Peugeot 307 SW station wagons. Ideal for professional workshops and DIY mechanics searching by product codes 6350X3 or 6350X2. This driver-side lamp restores rear lighting functions (tail/stop/indicator/position) and matches the original mounting points for a direct fit on compatible 307 SW models.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 307 SW (307 I / 307 II) — Station Wagon, Driver’s Side
- Product Codes: 6350X3, 6350X2
- Other Numbers: Not Specified
- Condition: Used
Compatibility
Fits Peugeot 307 SW (station wagon) models from 2005 onward. Check body style: left rear (driver’s side) tail lamp. Commonly referenced by OE codes 6350X3 and 6350X2 — useful keywords for quick lookup in parts catalogs and search engines.
Function
The assembly houses the rear position (tail), brake (stop), and indicator lamps. It provides required visibility and signaling at the rear of the vehicle and contributes to watertight rear-end sealing when mounted correctly. Bulb sockets are not included and must be supplied separately if transfer from the old unit is not possible.
Replacement Guide
- Preparation: Park on level ground, switch off ignition and, for general electrical safety, isolate the battery if you will be working on connectors or bulbs.
- Access: Open the tailgate and remove any interior trim panels or access covers to reach the lamp retaining screws.
- Remove: Unscrew fasteners, release retaining clips, gently pull the lamp assembly outwards and unplug the wiring harness.
- Transfer/Install: If bulb sockets are being reused, transfer them from the old lamp. Fit the new lamp into the mounting, reconnect the harness and secure all fasteners.
- Test: Verify all functions — tail, brake, and indicator lights — before refitting interior trims.
Installation Recommendations
- Use correct-sized tools to avoid damaging plastic tabs or screws.
- Replace worn or corroded bulb sockets and connectors to ensure reliable contact and sealing.
- Apply dielectric grease to connector pins to reduce corrosion risk in damp environments.
- Ensure the lens seals flush against the body to prevent moisture ingress; damaged seals should be replaced.
- After installation, check alignment and secure mounting to avoid vibration-related failures.
Common Failure Causes
Rear lamp assemblies typically fail due to mechanical impact (bumps or collisions), cracked or degraded lenses, failed or corroded bulb sockets, compromised seals allowing water ingress, and broken mounting tabs from over-tightening or repeated removal. Electrical issues often originate at corroded connectors rather than the lamp housing itself.
Why Choose This Part
This left rear lamp is a practical replacement for technicians and experienced DIYers who need a direct-fit solution identified by OE-style codes 6350X3 / 6350X2. It helps restore full rear lighting functionality and road safety while keeping repair time and complexity low when correct installation procedures are followed.
