Heater Fan and Air Conditioning Blower Citroën Peugeot 6441J9 1606357480

Description

Heating and Air Conditioning Blower Fan For Peugeot 206 And 206+

High-quality replacement blower motor designed for the heating and air conditioning system of Peugeot 206 and 206+ models. Supplied with original PSA references 6441J9 and 1606357480, this unit restores reliable airflow, quiet operation and efficient cabin climate control. Ideal for professional garages and experienced DIYers looking for a direct-fit solution that is commonly searched by OE number. The blower is engineered to deliver consistent ventilation across all fan speeds, improve defogging performance and ensure passenger comfort in all seasons.

Technical Information

• Manufacturer: Citroën / Peugeot (Stellantis)
• Model: Peugeot 206, Peugeot 206+
• Product Codes: 6441J9, 1606357480
• Additional Numbers: –

Function And Benefits

The blower motor circulates air through the vehicle’s HVAC system. It supplies airflow for heating, ventilation and air conditioning, supports rapid windscreen demisting and controls cabin air distribution according to fan-speed settings. A properly working blower ensures even temperature distribution, reduces HVAC system strain and contributes to overall comfort and safety.

Common Failure Causes And Typical Lifespan

• Wear Of Brushes Or Bearings: Mechanical wear in brushed motors leads to noise, reduced speed and eventual seizure.
• Contamination: Leaves, dust and debris drawn into the intake can obstruct the fan wheel or damage the motor.
• Electrical Issues: Corroded connectors, poor grounds or damaged wiring can cause intermittent operation or complete failure.
• Overheating And Moisture: Long exposure to moisture or overheating shortens component life.

Expected Service Life: Varies with use and environment; many units last 8–15 years (roughly 100,000–200,000 km) but high-moisture or dusty conditions accelerate wear.

Replacement Procedure (Overview)

Designed for technicians and competent DIYers. Basic steps:

1. Disconnect The Battery Before Starting To Prevent Short Circuits.
2. Access The Blower Motor: Typically located behind the glovebox or under the passenger-side dashboard. Remove the glovebox and any trim panels as required.
3. Disconnect Electrical Connector And Any Vacuum Lines/Clips.
4. Remove Mounting Screws Or Clips And Extract The Blower Assembly From The Housing.
5. Fit The New Unit, Secure Mounting Fasteners, Reconnect Electrical Connector And Reassemble Trim.
6. Reconnect The Battery And Test All Fan Speeds, Including Heater And A/C Operation.

Installation Recommendations

• Always Disconnect The Battery Before Removing The Blower Motor.
• Inspect And Replace The Cabin Air Filter If Heavily Contaminated To Prevent Premature Failure Of The New Unit.
• Check Wiring, Fuses And Fan Resistor/Control Module—A Faulty Resistor Or Control Module Can Cause The New Blower To Malfunction.
• Use Correct Fasteners And Avoid Over-Tightening To Prevent Housing Distortion.
• After Installation, Verify Smooth Operation At All Speed Settings And Listen For Any Rubbing Or Unusual Noises.

Why Choose This Unit

Supplied to match known PSA references (6441J9 / 1606357480), this blower motor is a practical choice for professional repairs and quality DIY replacements. Fast identification by OE number improves searchability and speeds up procurement for workshops handling Peugeot 206/206+ climate system repairs.

Notes

When replacing the blower, also inspect the blower fan wheel and surrounding housing for debris accumulation or damage. Proper attention during installation will extend the service life of the new unit and help maintain efficient HVAC performance.