Description
Seat Airbag for Citroën C3 from 2009 Driver’s Seat
Description
High-quality driver seat airbag designed for Citroën C3 II (A51) models from 2009. This seat-mounted airbag module (OE number 9802546080) is a direct replacement part intended for professional workshops and experienced DIY mechanics who perform interior and SRS repairs. The module restores occupant protection in the event of a side impact and works as part of the vehicle’s Supplemental Restraint System (SRS). Clear product identification by part number makes ordering and fitment straightforward for technicians and parts specialists.
Technical Information
- Manufacturer: Stellantis / Citroën
- Model: Citroën C3 II (A51) – Driver’s Seat
- Product Codes: 9802546080
- Other Numbers: None Available
Function
The seat airbag is a pyrotechnic restraint located in the side of the driver’s seat. In a qualifying collision, it inflates within milliseconds to provide lateral protection for the torso and pelvis, reducing risk of injury. It works together with seatbelt pretensioners and other SRS components to manage occupant forces during impact.
Compatibility / Fitment
Intended for Citroën C3 II (A51) models from 2009 for the driver’s seat. Compatibility is typically determined by the OEM part number 9802546080; ensure the part number matches the original module on the vehicle before installation. This module is normally fitted in vehicles equipped with side/seat airbags.
Replacement Procedure
Basic replacement steps (for experienced technicians):
- Disconnect the negative battery terminal and wait at least 10 minutes to allow SRS capacitors to discharge.
- Move the seat to gain access to trim fasteners, then carefully remove seat covers and trim to expose the airbag housing.
- Unplug the airbag electrical connector(s) using appropriate SRS-safe tools and methods; label connectors if necessary.
- Unbolt the airbag module from the seat frame and remove it, taking care to keep the airbag facing away from you and any sensitive components.
- Install the new module in reverse order: secure mounting bolts to manufacturer specifications, reconnect connector(s) firmly, refit trim and upholstery.
- Reconnect the battery and verify SRS system status with a diagnostic tool; clear any stored fault codes if necessary.
Installation Recommendations
Always follow the vehicle manufacturer’s service manual. Important safety points:
- Work Only With The Battery Disconnected And Observe SRS Safety Procedures.
- Do Not Use Excessive Force Or Power Tools Directly On Airbag Components.
- Handle The Module With The Airbag Cushion Facing Away From You And Store Safely During Work.
- Replace Any Single-Use Fasteners Or Clips If The Manufacturer Specifies Them.
- After Installation, Verify System Integrity With A Diagnostic Scanner And Ensure The Airbag Warning Light Remains Off.
Common Failure Reasons
Seat airbags generally remain functional for the life of the vehicle unless one of the following occurs:
- Deployment In A Collision — Airbag Will Need Replacement After Activation.
- Water Or Corrosion Damage From Seat Wetting Or Moisture Ingress — Electrical Contacts Can Fail.
- Mechanical Damage During Seat Removal/Installation Or From Aftermarket Modifications.
- Connector Fatigue Or Wiring Chafing Caused By Seat Movement Over Time.
- Previous Improper Repairs Or Tampering That Compromise The Module.
Notes For Purchase
Order by OEM part number 9802546080 to increase the chance of correct fitment. This module is aimed at professional garages and skilled DIY mechanics familiar with SRS procedures. Proper handling and installation are critical for occupant safety.
