Description
Speaker for Citroën, Peugeot, Opel and DS vehicles
This speaker (Part No. 9809320280) is a direct-fit audio replacement for a range of Citroën, Peugeot, Opel and DS models. Built to restore factory-fit sound staging and installation accuracy, it is suitable for professional workshops and confident DIY mechanics who search parts by OEM code. The unit fits original speaker locations and connectors used on compatible models, helping you replace damaged or degraded speakers quickly and reliably.
Features And Function
The speaker converts electrical audio signals into sound with a construction compatible with original equipment. It is intended as a direct replacement to maintain correct mounting, acoustic alignment and connector fit. Typical uses include replacement of failed door or dashboard speakers, upgrade from worn OEM units and restoration of balanced in-car sound.
Technical Information
- Manufacturer: Stellantis
- Model: Citroën Berlingo III; Citroën Berlingo K9; Citroën C3 III; Citroën C4 II; DS3; DS4; DS5; DS7; Opel Combo E K9; Peugeot 2008; Peugeot 208; Peugeot Rifter; Peugeot 508
- Product Codes: 9809320280
- Additional Numbers: Not Available
Installation Recommendation
- Prepare Tools: Panel trim tools, Torx/Screwdriver set, multimeter, and suitable fasteners if originals are damaged.
- Procedure: Remove interior trim/panel to access the speaker. Unscrew the speaker, unplug the connector and gently remove the old unit. Fit the new speaker, reconnect the connector checking polarity, secure with original screws and reassemble trim.
- Safety: Disconnect the negative battery terminal before working on vehicle electrics to avoid short circuits and accidental airbag deployment.
- Final Check: Test audio at low volume first, verify polarity and secure mounting to avoid rattles. Replace speakers in pairs when possible to preserve balanced audio.
Why This Part Most Often Fails
- Age And Wear: Foam surrounds and cones degrade over time causing distortion or loss of sound.
- Water Ingress: Moisture from leaks or door seals can corrode terminals and damage the voice coil.
- Overpowering: Excessive amplifier power or prolonged high-volume use can burn the voice coil.
- Mechanical Damage: Impact or stressed mounting causes rattles, torn cones or broken frames.
- Connector Corrosion: Poor electrical contact leads to intermittent sound or complete failure.
Testing And Practical Tips
- Quick Test: Use a multimeter to check coil continuity (low ohm resistance indicates intact voice coil). No continuity suggests an open coil.
- Polarity: Mark and preserve positive/negative wiring to maintain correct stereo imaging on reinstallation.
- Replacement Advice: If one speaker is damaged, consider replacing the opposite side to maintain tonal balance.
- Acoustic Fit: Use original mounting points and gaskets where possible to avoid air leaks and vibration noise.
Order by Part Number 9809320280 to ensure quick matching with your repair job. This speaker gives a reliable OEM-fit replacement and is commonly searched by its product code for fast identification and procurement.
