Description
Steering column controls, multifunction DELPHI COM2003 stalk from a 2005 PEUGEOT 307 CC. Controls fog lights, trip computer, front wipers, rain sensor, ESP, cruise control and car radio (cruise control and radio functions require the corresponding stalk module to be supplied or swapped).
This multifunction steering column stalk is a direct-fit replacement for Citroën and Peugeot vehicles using the DELPHI COM2003 system. Designed for professional workshops and experienced DIYers, the unit restores control of lighting, wipers, on-board computer functions and vehicle stability interfaces. Sourced from OEM-compatible hardware, it provides reliable mechanical switching and electrical signalling for systems such as fog lights, front wipers with rain-sensor input, ESP interaction and driver information controls. Including the common part numbers used in searches increases discoverability for mechanics who look up parts by code.
Technical Information
- Manufacturer: Delphi (used on Stellantis Citroën / Peugeot vehicles)
- Model: Multifunction Stalk / DELPHI COM2003
- Product Codes: 96635796XT, 98069979XT, 6242AA
- Additional Numbers: Common OEM reference for Peugeot/Citroën multi-function stalks
Compatibility
Typical fitment includes a range of Citroën and Peugeot models that use the Delphi COM2003 steering column switch family. Commonly found on:
- Peugeot 307 (including 307 CC) – from 2005
- Peugeot 206
- Peugeot 406
- Peugeot 807
- Peugeot Berlingo II
- Citroën C5 I
- Citroën C8
Always verify part numbers (96635796XT / 98069979XT / 6242AA) against the unit you remove to ensure correct match.
Installation Recommendation
Installation requires care around steering and airbag components. Recommended steps for safe replacement:
- Disconnect the vehicle battery and wait at least 10 minutes before starting work to allow residual power to discharge.
- Follow the vehicle manufacturer’s service manual for airbag removal and steering wheel disassembly. If you are not qualified to handle airbag systems, have the removal and reinstallation performed by a trained technician.
- Remove the steering wheel trim and column shrouds to access the stalk assembly, unplug the electrical connectors and remove mounting screws. Fit the new stalk, reconnect connectors and reassemble in reverse order.
- After installation, test all functions (wipers, rain sensor, fog lights, trip computer commands, ESP communications). If cruise control or radio commands are not present, transfer or install the appropriate control stalk or module as required.
Why This Part Fails Most Often
Multifunction stalks are subject to both mechanical and electrical wear. Common failure causes include:
- Wear of internal contacts from repeated switching, causing intermittent or failed signals.
- Moisture ingress or corrosion in connector pins leading to poor electrical continuity.
- Broken plastic levers or mounting points due to mechanical impact or age-related embrittlement.
- Faulty rain sensor wiring or interrupted CAN/ESP signal paths that make functions appear to fail even when the stalk is mechanically sound.
Practical Notes
If cruise control or radio steering controls are not working after swapping the stalk, the vehicle may require the corresponding control stalk to be transferred from the donor unit or an additional module to be fitted. Some vehicles rely on matching the wiring pinout and connectors exactly; ensure the replacement unit matches the connector layout and part codes listed above.
Who Should Fit This Part
Suitable for professional mechanics and experienced DIYers familiar with steering column and airbag procedures. If in doubt about airbag handling or electrical diagnostics, seek professional workshop support.
