Description
Interior roof light for Citroën and Peugeot vehicles
Premium replacement interior roof light (dome light) designed for Citroën and Peugeot models. Ideal for professional workshops and DIY mechanics searching by part number 6362P3. This overhead lamp restores cabin illumination, map/reading light functions and contributes to a tidy interior finish after repair or panel work. Compatible with multiple small Stellantis platform models and supplied to match original mounting points and connector layout for straightforward fitment.
Compatibility
Fits the following models as commonly referenced by the part code 6362P3:
- Citroën C1
- Peugeot 107
- Peugeot 206
- Peugeot 206+
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën C1; Peugeot 107; Peugeot 206; Peugeot 206+
- Product Codes: 6362P3
- Other Numbers: No additional reference numbers provided
Function
The unit provides interior roof illumination including central cabin light and reading/map light functionality where applicable. It supplies switched lighting controlled by door contacts and the manual rocker/switch on the lamp module, and includes the mounting and connector interface for integration with the vehicle interior wiring harness.
Typical Failure Modes
- Burnt or blown bulb (in versions with replaceable bulbs).
- Faulty internal switch or contact wear causing intermittent operation.
- Broken plastic mounting clips or housing damage from improper removal.
- Corrosion or wiring connector issues leading to loss of power or flicker.
- Ingress of moisture or dirt in older vehicles affecting contacts.
Replacement Procedure
- Prepare: Park vehicle on a level surface, switch off ignition and remove key.
- Safety: Disconnect the negative battery terminal if you will work on the electrical connectors for extended time or if recommended by workshop practice.
- Remove Trim: Use plastic trim tools to gently pry out the lamp bezel to avoid breaking clips or scratching headliner.
- Unplug: Disconnect the electrical connector from the lamp module by depressing the locking tab and pulling straight out.
- Swap Unit: Remove the old lamp and install the replacement, ensuring correct orientation and secure seating of clips.
- Reconnect: Plug the electrical connector back in, test lamp functions (door-activated, switched, and reading lamp) before final assembly.
- Reassemble: Snap the bezel back into place until all clips engage and reconnect the battery if previously disconnected.
Installation Recommendations
Always use non-marring plastic trim tools to remove the lamp bezel and avoid damaging the headliner or plastic clips. Inspect the connector for corrosion and the wiring for signs of wear before installing the new unit. If the lamp version includes a replaceable bulb, check the bulb type and rating and replace with the correct specification. Typical replacement time for an experienced technician is 15–30 minutes.
Why This Part Often Fails
Interior roof lights are frequently subject to mechanical stress during repairs or improper removal, causing broken clips or cracked housings. Electrical failures are commonly caused by worn internal switches, blown bulbs or corrosion in connectors—especially in older vehicles. Regular use and exposure to dirt or moisture over many years accelerates wear of contacts and moving parts.
Notes
Searchable by part number 6362P3 — a common reference used in parts catalogs and workshop listings. Suitable for professional replacement and DIY projects where fast, reliable cabin lighting restoration is required.
