Description
Right exterior mirror for CITROËN C5 from 2005, can also be used on models up to 2005. Electrically operated, electrically foldable to the vehicle, heated, temperature sensor. Color EWP – Paint White Banquise. 12 Pin (6+6). Passenger Side.
This right-side replacement mirror is designed for fast, reliable service in workshops and for experienced DIY mechanics. It restores full functionality — electric adjustment, power folding, heating and temperature sensing — and is supplied in EWP (White Banquise) finish. Ideal for repairing accident-damaged mirrors or replacing units with faulty motors or heaters. Common search terms: Citroën C5 right mirror, 96532993XT mirror, electric folding mirror, heated side mirror.
Features
- Electric Adjustment: Precise mirror orientation via vehicle switch.
- Electric Folding: Motorised folding for parking protection.
- Heated Glass: Integrated heater to clear frost and condensation.
- Temperature Sensor: Supports automatic mirror functions and climate-related features.
- 12-Pin Connector (6+6): Standard electrical interface for Citroën C5 wiring harness.
- Colour: EWP / Paint White Banquise. Passenger Side (Right).
Technical Information
- Manufacturer: Stellantis (Citroën)
- Model: Citroën C5
- Product Codes: 96532993XT, 532993XT, 8149WH
- Additional Numbers: EWP (Paint White Banquise), 12 Pin (6+6), Passenger Side
Compatibility
Fits Citroën C5 models (Phase I and Phase II) around the mid-2000s. Check that the vehicle uses a 12-pin (6+6) mirror connector and the passenger-side mirror geometry matches the original unit before installation. Product codes such as 96532993XT are commonly used when searching for the correct replacement part.
Installation Recommendations
- Safety First: Disconnect the battery before starting work to avoid short circuits and accidental airbag deployment.
- Remove Interior Trim: Carefully remove the door trim or the small triangular trim panel to access the mirror fixing bolts and connector.
- Disconnect Connector: Unplug the 12-pin electrical connector (6+6) and check for corrosion or damaged pins; apply dielectric grease if needed.
- Remove Fasteners: Unscrew the mirror mounting bolts, support the mirror while removing to avoid drops or paint damage.
- Fit New Mirror: Position new mirror, tighten bolts to manufacturer torque if available, plug in the connector and reassemble the trim.
- Function Check: Verify electric adjustment, folding, heating and temperature sensor functions. Cycle folding and test heater operation (may require ignition on).
- Final Check: Ensure mirror glass is firmly seated and there is no rattle. Adjust mirror positions and confirm door closes without interference.
Most Common Causes Of Failure
- Impact Damage: Collisions and door knocks are the most frequent cause — broken housings, cracked glass, and snapped folding mechanisms.
- Motor Wear: Repeated folding and adjustment can wear bearings and small motors, leading to loss of movement or noisy operation.
- Water Ingress And Corrosion: Moisture can corrode connectors and motors, causing intermittent or permanent electrical failure.
- Heater Element Failure: The heating grid can degrade over time or fail due to electrical faults.
- Wiring And Connector Issues: Bent pins, broken wires or poor grounding cause loss of function or erratic behaviour.
Replacing the mirror with a correct-code unit (for example 96532993XT) typically restores full functionality. For professional repairs, inspect the door harness and connector pins during replacement to prevent repeat failures.
