Left rear door lock for Peugeot 206 and 406 Estate, Part No. 913758

Description

Electric central locking lock for the left rear door. For Peugeot 206 and 406 Combi.

This electric central locking unit (left rear door) is a direct replacement designed for Peugeot 206 and Peugeot 406 Combi models. Ideal for professional mechanics and DIY enthusiasts, the part restores secure locking, reliable remote central locking operation and eliminates issues such as intermittent locking, noisy operation or total failure when opening or closing the left rear door. The part is frequently searched by its product code 913758, so including that number in searches helps customers find the correct item quickly.

Technical Information

• Manufacturer: Stellantis / Citroën / Peugeot
• Model: Peugeot 206; Peugeot 406 Combi
• Product Codes: 913758
• Other Numbers: Not Available

Function And Fitment

The unit actuates the locking mechanism inside the left rear door as part of the vehicle’s central locking system. It converts the electrical signal from the remote or central locking switch into mechanical movement that locks or unlocks the door latch. Correct fitment ensures synchronized operation with the vehicle’s existing door latch, rods and wiring harness.

Replacement Procedure (Overview)

1. Remove Inner Door Trim: Carefully pry off door trim and disconnect any switches or courtesy lights to access the lock assembly.
2. Disconnect Electrical Connector: Unplug the actuator wiring harness from the central locking connector.
3. Detach Linkages: Note and mark the positions of the lock rods and clips; then carefully unclip the linkages from the actuator.
4. Remove Mounting Fasteners: Unscrew the actuator mounting bolts or rivets holding the unit to the door shell.
5. Install New Unit: Position the new actuator, secure fasteners, reconnect linkages and electrical connector. Ensure rods are connected in the same orientation as removed.
6. Test Before Reassembly: Operate the central locking from the remote and door switch to confirm correct operation, then re-fit the door trim.

Installation Recommendations

• Use Proper Tools: Plastic trim tools reduce the risk of damaging clips and door trim. Keep a small torch handy for visibility inside the door.
• Mark Linkage Positions: Label rod positions and clip orientation before removal to ensure correct reassembly and avoid misalignment.
• Protect Electrical Connectors: Clean contacts if corroded and ensure a secure, moisture-free connection to prevent intermittent faults.
• Test Thoroughly: Always test locking/unlocking cycles, both with key fob and interior switches, before reinstalling the door card.

Most Common Failure Causes

• Water Ingress And Corrosion: Moisture entering the door cavity can corrode electrical contacts or internal gears, causing intermittent or permanent failure.
• Mechanical Wear: Plastic gears and linkages inside the actuator wear over time, especially on high‑use doors, leading to noisy or failed operation.
• Electrical Faults: Damaged wiring, poor connector contact or blown fuses can prevent the actuator from receiving power.
• Impact Or Damage: Door impacts or slammed doors can bend linkages or damage mounting points, affecting actuator function.

Replacing the left rear door actuator is a cost‑effective repair that restores convenience and security to the central locking system. For searches, include model and the part number 913758 to quickly find the correct replacement unit for Peugeot 206 and Peugeot 406 Combi vehicles.