Description
Steering Wheel Airbag, Driver Airbag For Peugeot 206+ And 207
Color HZD – Black Mistral
Single Inflator
This steering wheel airbag is a direct-fit driver airbag designed for Peugeot 206+ and Peugeot 207 models. Supplied in Black Mistral (color code HZD) with a single inflator, it is intended for professional repairs and serious DIY mechanics who require a correct OEM-style replacement. The part is commonly searched by reference numbers, so the listed product codes are included below to help you find the exact match for your vehicle.
Key Features
– Direct replacement driver airbag designed to fit the original steering wheel mounting points.
– Black Mistral upholstery for a factory appearance inside the vehicle.
– Single inflator configuration suitable for the listed Peugeot models.
– Ideal for garages and experienced DIYers performing SRS repairs after airbag deployment or damage.
Technical Information
- Manufacturer: Stellantis (Peugeot/Citroën)
- Model: Peugeot 206+; Peugeot 207
- Product Codes: 96857294ZD, 4112PK, 4112NW
- Additional Numbers: None Known
Fitment And Function
The unit replaces the driver-side airbag module located in the center of the steering wheel. It is a safety device designed to deploy in a collision to protect the driver. This airbag contains a pyrotechnic inflator (single-stage) and must be replaced after deployment. It restores original look and SRS functionality when fitted correctly.
Installation Recommendations
Only qualified personnel or experienced mechanics should install SRS components. Recommended general procedure:
- Disconnect the negative battery terminal and wait at least 10 minutes before starting work to allow the SRS capacitors to discharge.
- Follow the vehicle manufacturer’s procedure to remove the steering wheel trim/horn pad and access the airbag module.
- Carefully disconnect the airbag electrical connector(s) and remove fasteners holding the airbag module in place.
- Install the new module, secure fasteners to manufacturer torque settings, reconnect connector(s) and reassemble trims.
- After installation, clear any SRS fault codes and verify airbag system status with a diagnostic tool; ensure the SRS indicator behaves normally.
Safety Note: Handle airbags with care, store with the pad side up, avoid heat and impact, and never attempt to modify or repair the inflator.
Why This Part Fails
Typical reasons for replacement:
- Deployment In A Collision — Airbags Are Single-Use and Must Be Replaced After Deployment.
- Physical Damage — Impact, Improper Previous Repairs Or Damage To The Module Can Require Replacement.
- Electrical Or Connector Issues — Corroded or Damaged Wiring And Connectors Can Cause SRS Faults Indicating The Module Needs Inspection Or Replacement.
There Is No Routine Time-Based Replacement Interval; Replace The Module After Deployment Or If It Is Damaged Or Generates Persistent SRS Faults.
Notes For Mechanics And DIYers
This product is suitable for professional workshops and experienced technicians performing SRS system repairs. Always use proper diagnostic equipment to confirm system status after replacement. If the SRS warning lamp remains lit after fitting, diagnose and clear codes with the appropriate PSA diagnostic tool to ensure the system is fully operational.
