Description
Rear right lamp for the tailgate for Citroën C4 Picasso vehicles. Passenger side.
Product Overview
Complete Rear Right Tailgate Lamp Assembly designed as a direct replacement for the original equipment on Citroën C4 Picasso models. This unit restores the tailgate lighting functions — including position, brake and reversing lights where applicable — and matches the factory fit and connectors for straightforward installation. Ideal for professional garages and experienced DIY mechanics searching by OE numbers such as 9673164980 or 6351CC.
Compatibility
Designed For Citroën C4 Picasso Vehicles (Including Grand C4 Picasso). Passenger Side Fitment (Right-Hand Side In Left-Hand Drive Vehicles). Check Product Codes Below For Exact Match With Your Vehicle.
How To Replace
Replacement Is A Relatively Straightforward Job For A Professional Or A Skilled DIYer. Typical Time: 20–45 Minutes Depending On Equipment And Access. Basic Steps:
- Open The Tailgate And Secure It In The Open Position.
- Remove The Inner Tailgate Trim Panel Using Trim Tools To Avoid Damage.
- Unscrew The Lamp Fasteners (Torx/Screw Type May Vary) And Carefully Pull The Lamp Outwards.
- Disconnect The Electrical Connector And Any Bulb Holders If Present.
- Fit The New Lamp Assembly, Reconnect The Electrical Connector, And Reinstall Fasteners.
- Test All Lighting Functions Before Reattaching The Trim Panel.
Technical Information
- Manufacturer: Stellantis (Citroën)
- Model: Citroën C4 Picasso (Including Grand C4 Picasso)
- Product Codes: 9673164980, 6351CC
- Additional Numbers: NFP
Installation Recommendations
- Disconnect The Battery Before Starting Work And Follow Standard Safety Procedures.
- Use Proper Trim Removal Tools To Avoid Damaging Interior Panels.
- Keep Fasteners Organized And Refit With Correct Torque To Ensure A Watertight Seal.
- Check And Clean The Electrical Connector Contacts; Apply Dielectric Grease If Needed To Prevent Corrosion.
- Inspect Tailgate Seal And Mounting Points For Damage Or Misalignment That Could Cause Future Leaks Or Stress.
- After Installation, Verify All Light Functions (Position, Brake, Indicator, Reverse) And Error Messages On The Dashboard.
Most Common Failure Reasons
The Most Frequent Causes Of Tailgate Lamp Failure Are Moisture Ingress, Physical Damage From Impacts Or Loading, Corrosion Of Electrical Connectors And Cracked Lenses Or Seals. Poor Tailgate Alignment Or Damaged Seals Can Accelerate Water Penetration Leading To Short Circuits Or LED Module Failure. Environmental Factors Such As Road Salt And High Humidity Increase The Risk Of Corrosion. Lifespan Varies With Use And Exposure; Many Failures Occur After Impact Events Or When Seals Have Deteriorated Over Time.
Notes
Order By OE Code To Ensure Correct Fitment. This Unit Is Supplied As A Replacement Lamp Assembly For The Specified Models And Should Be Installed By A Qualified Technician Or An Experienced DIY Mechanic Following The Vehicle Manufacturer’s Procedures.
