Description
Steering wheel airbag for Citroën C5 I and II
Color HZE – TRAMONTANE
This driver airbag module is intended as a direct-fit replacement for Citroën C5 first and second generation steering wheels. It restores the steering-wheel appearance and the primary occupant protection function after deployment or component failure. The unit is suitable for professional workshops and skilled DIY mechanics and is often searched by its product codes, increasing findability in online searches.
Technical Information
- Manufacturer: Stellantis / Citroën
- Model: Citroën C5 I, Citroën C5 II
- Product Codes: 96509314ZE, 96326381ZE
- Additional Numbers: 4112GF, 4112HC, NFP
- Color: HZE – Tramontane
- Type: Driver (Steering Wheel) Airbag Module
Installation Recommendations
Safety first: Disconnect the negative battery terminal and wait at least 10 minutes to allow the SRS capacitors to discharge. Work in a dry, well-lit environment and keep the airbag module facing upward when removed. Typical replacement steps:
- Remove the steering wheel trim or covers to access the airbag retaining screws (follow vehicle-specific procedure).
- Unscrew and carefully lift the airbag module; unplug electrical connectors gently—avoid pulling on wires and fragile connector latches.
- Install the new airbag module, reconnect connectors and wiring, and secure the module with the original fasteners.
- Reconnect the battery, then verify that the SRS warning light behaves according to the vehicle manual; clear codes with a diagnostic tool if required.
Always use the vehicle manufacturer’s torque values and repair manual procedures. If uncertain about the clock spring condition or airbag electrical faults, consult workshop documentation or diagnostic equipment.
Why The Part Fails Most Often
Airbag modules do not have a routine service interval; failures are typically caused by the following:
- Previous Deployment: Airbags must be replaced after a crash deployment.
- Electrical Problems: Damaged connectors, broken wires in the steering column or faulty clock spring (spiral cable) can interrupt the circuit and trigger SRS faults.
- Corrosion Or Water Ingress: Moisture in the steering column area can corrode contacts and cause malfunction.
- Physical Damage: Impact, tampering or improper removal/installation can damage the module or its connectors.
Replacing related components (clock spring, connectors) is often required to fully resolve SRS warnings.
Fitment Notes
Fits Citroën C5 first and second generation steering wheels configured with color code HZE (Tramontane). Customers commonly search using the product numbers listed above—verify the part number against the vehicle’s existing airbag marking before installation.
